Related Experiment Video
Updated: Jun 12, 2026

The Use of Thermal Infra-Red Imaging to Detect Delayed Onset Muscle Soreness
Published on: January 22, 2012
Comparing muscle temperature during static and dynamic squatting with and without whole-body vibration
D J Cochrane1, S R Stannard, E C Firth
1Sport Management and Coaching, Department of Management, Massey University, Palmerston North, New Zealand. D.Cochrane@massey.ac.nz
Abstract:
The aim of this study was to investigate the influence of shallow dynamic squatting (DS) versus static squatting (SS) with or without concurrent side-to-side alternating whole-body vibration (WBV) on vastus lateralis temperature and cardiovascular stress as indicated by heart rate (HR). Ten participants (five men, five women) participated in four interventions [DS with WBV (DS+), DS without WBV (DS-), SS with WBV (SS+), SS without WBV (SS-)] 48 h apart, in a randomized order. The interventions were preceded by a approximately 20-min rest period, consisted of 10 mins with or without WBV (26 or 0 Hz) with SS (40 degrees of knee flexion) or DS (55 degrees of knee flexion, at a cadence of 50 bpm) where SS+ and DS- were metabolically matched. Muscle (T(m)), core (T(c)), skin temperature (T(sk)), HR and VO(2) were recorded during each intervention. For T(m), there was a time (P<0.01) and WBV (P<0.01) effect but no squat effect was evident, and there was time xWBV interaction effect (P<0.01). In all four interventions, the work load was too low to cause cardiovascular stress. Instead normal, moderate physiological effects of exercise on autonomic control were observed as indicated by HR; there were no significant increases in T(sk) or T(c). There appears to be no benefit in performing an unloaded, shallow DS+ at a tempo of 50 bpm as T(m,) HR, VO(2) are likely to be increased by the same amount and rate without WBV. However, combining SS with WBV could be advantageous to rapidly increasing soft tissue temperature prior to performing rehabilitation exercises when dynamic exercise cannot be performed.
Related Concept Videos
Assessing Body Temperature - Axilla
Step 1: Perform hand hygiene and put on clean gloves to maintain infection control and prevent cross-contamination.
Step 2: Prepare the patient by explaining the procedure to ensure understanding and cooperation. Ensure privacy, expose the axilla, and inform the patient that minimal movement is crucial for an accurate reading.
Step 3: Adjust the patient’s clothing to expose only the axilla. It minimizes...
Muscle Stimulation Frequency
Wave summation
At low firing rates, motor neurons induce individual twitch contractions in muscle fibers. These twitches...
Assessing Body Temperature - Rectal
Follow these steps for rectal temperature assessment:
Step 1: Perform hand hygiene and don clean gloves to prevent cross-infection.
Step 2: Position the patient in a side-lying position to better visualize the rectal...
Isotonic and Isometric Muscle Contractions
Isotonic contractions
Isotonic contractions occur when a muscle changes length while the...
Assessing Body Temperature - Temporal Artery
Step 1: Perform hand hygiene and don a fresh pair of gloves to prevent cross-infection and ensure patient safety.
Step 2: Explain the procedure to the patient to establish trust. Clear communication establishes trust with the patient, ensures they understand what to expect, promotes cooperation, and enhances comfort during the procedure.
Step 3: Assess the patient's forehead...
Equipments Used to Measure Body Temperature
Glass-bulb Thermometer:
Glass-bulb thermometers are hollow glass tubes with a bulb tip containing liquid such as ethanol or mercury. Historically, glass bulb mercury thermometers were the standard device to measure body temperature. Today, mercury thermometers are prohibited in many countries due to the hazardous effects of mercury and the risk of exposure if the glass bulb breaks. In general,...