Related Experiment Video
Updated: Jun 12, 2026

Phase Diagram Characterization Using Magnetic Beads as Liquid Carriers
Published on: September 4, 2015
Determining scaling in known phase diagrams of nonionic microemulsions to aid constructing unknown
1Department of Chemistry, University of Coimbra, Portugal. Joakim.Balogh@fkem1.lu.se
Abstract:
Microemulsions based on nonionic surfactants of the ethylene oxide alkyl ether type C(m)E(n), have been studied thoroughly for around 30 years. Thanks to the considerable amount of published data available on these systems, it is possible to observe trends to make predictions of phase diagrams not yet determined. Strey and Kahlweit, and subsequently Sottmann and Strey, with coworkers have studied and published phase diagrams for systems with a fixed ratio of oil to water, varying the surfactant, the so-called Kahlweit fish-cut diagrams. Some properties of the phase diagrams can be scaled to become general and not system dependent. Here are shown two examples of scaling data from phase diagrams and the use of trends to determine phase diagrams, both inside and outside a dataset. The trends of microemulsions with fixed ratio of surfactant to oil, the so-called Lund-cut diagrams, are also investigated. The trends are used to determine a new phase diagram and this is compared with previously unpublished experimental data on C(12)E(5)-Octadecane-Water system. The scalings and trends make it possible to get good estimations of many of the important properties of the phase diagrams, both temperatures and surfactant concentrations of interest, by investigating one sample in the 3-phase region of the balanced fish-cut diagram.
Related Concept Videos
Electrochemical Systems
Phase Diagrams of Ternary Systems
Micelles
Freezing Point Depression and Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
Solid–Solid Solutions
Two Components: Liquid–Liquid Systems
