Related Experiment Video

Updated: Jun 12, 2026

Transmission of Multiple Signals through an Optical Fiber Using Wavefront Shaping
09:43

Transmission of Multiple Signals through an Optical Fiber Using Wavefront Shaping

Published on: March 20, 2017

Beam shaping for uplink transmission of a relay mirror system

Huiyun Wu1, Haichuan Zhao, Xiaojun Xu

  • 1College of Optoelectronic Science and Engineering, National University of Defense Technology, Changsha 410073, China. huiyun-wu@163.com

Applied Optics
|June 12, 2010
PubMed

More Related Videos

A Guide to Structured Illumination TIRF Microscopy at High Speed with Multiple Colors11:15

A Guide to Structured Illumination TIRF Microscopy at High Speed with Multiple Colors

Published on: May 30, 2016

Related Concept Videos

Directional Relays01:25

Directional Relays

Directional relays, essential for managing unidirectional fault currents, enhance the safety and efficiency of power systems. On power lines equipped with directional relays, faults downstream (to the right) of the current transformer typically cause the fault current to lag the bus voltage by approximately 90 degrees, known as the forward direction. In contrast, upstream (left-side) faults may result in the fault current leading the bus voltage by nearly 90 degrees, termed the reverse...
Bewley Lattice Diagram01:12

Bewley Lattice Diagram

The Bewley lattice diagram, developed by L. V. Bewley, effectively organizes the reflections occurring during transmission-line transients. It visually represents how voltage waves propagate and reflect within a transmission line, making it easier to understand the complex interactions that occur.
Transmission Line Design Considerations01:23

Transmission Line Design Considerations

Aluminum has become the material of choice for overhead transmission lines, surpassing copper due to its abundance and cost-effectiveness. The most prevalent type is the aluminum conductor, steel-reinforced (ACSR), which combines aluminum strands around a steel core. Other variants include all-aluminum conductors (AAC), all-aluminum alloy conductors (AAAC), aluminum conductor alloy-reinforced (ACAR), and aluminum-clad steel conductors. Advanced designs, such as aluminum conductors with steel...
Polar Coordinates: Problem Solving01:27

Polar Coordinates: Problem Solving

Directional radiation patterns are central to antenna analysis, as they illustrate how signal strength varies with direction. These patterns are often modeled using polar plots, where the radial distance from the origin represents signal intensity at a given angle. A commonly used idealized form is the four-lobed rose curve, which captures the concept of directional beams in a simplified mathematical form.The four-lobed rose curve, described by r = cos⁡(2θ), features four symmetric lobes, each...
Pilot and Numeric Relaying01:21

Pilot and Numeric Relaying

Pilot relaying is a type of differential protection used in power systems. It compares electrical quantities at the terminals of equipment via a communication channel instead of direct relay interconnection. This method is essential for transmission lines where the terminals are far apart, typically up to 80 km for lines with 69 to 115 kV ratings. Four types of communication channels are used for pilot relaying:
Differential Relays01:20

Differential Relays

Differential relays are used to protect generators, buses, and transformers by comparing electrical quantities at different points. When a fault occurs, the difference in current between the two points triggers the relay to operate, opening the circuit breaker. Under normal conditions, the current entering (i1) and leaving (i2) a generator are equal. When a fault occurs, however, these currents become unequal, and the difference current flows in the relay operating coil, causing the relay to...