Related Experiment Video
Updated: Jun 12, 2026
Split Hybridization Probe Utilizing a DNA Fluorescent Light-up Aptamer as a Signal Reporter for Sequence-Specific Nucleic Acid Analysis
Published on: July 8, 2025
Detection of DNA Sequence with Enhanced Sensitivity and Higher FRET Efficiency Using a Light-Emitting Polymer,
Nidhi Mathur1, Anamika Aneja, P K Bhatnagar
1a Materials Laboratory, Department of Electronic Science, University of Delhi South Campus, Benito Juarez Road, New Delhi-110021, India.
Abstract:
An improved strategy has been developed for detection of DNA sequence by using water-soluble cationic conjugated polymer (PFP)/single-strand (ss) DNA and peptide nucleic acid labeled with fluorescent dye (PNAC*), where an anionic surfactant (sodium dodecyl sulphate, SDS) system has been used to improve the sensitivity of the sensor. The method of detection is simple to use, fast and cost-effective. This method uses the phenomenon of Forester Resonance Energy Transfer (FRET). The detection sensitivity of the biosensor has been improved by about ten times by using the anionic surfactant. It is observed that the effect of surfactant is to increase the photoluminescence (PL) intensity of the PNAC* when the sequence of the DNA is complementary (to that of PNA probe). On the other hand when the two sequences are non-complementary, the PL intensity of the PNAC* is further reduced as compared to the case when surfactant was absent.
Related Concept Videos
03:31Labeling DNA Probes
Radioisotopes, fluorophores, or small molecule binding partners like biotin or digoxigenin, are the most widely used reporter tags for labeling DNA probes. These labels can be attached to the probe DNA molecule via...
02:57Southern Blot
Denatured DNA fragments must be transferred onto a carrier membrane from the gel to make it accessible to a probe - a small ssDNA fragment complementary to the target DNA...