Parameters governing reproducibility of flow properties of porous monoliths photopatterned within microfluidic...

We report the patternability as well as the reproducibility and stability of flow resistance of polymer monolithic beds photopatterned within microfluidic channels as a function of initial reagent composition and preparation conditions. 2-Hydroxyethyl methacrylate and ethylene dimethacrylate-based polymer monoliths were selectively photopatterned within microchannels and their flow resistance was evaluated using a photobleaching, TOF linear flow rate measurement method developed in our lab. This measurement technique was found to be significantly more informative for columns formed in microfluidic channels compared with bulk monolith characterization by mercury intrusion porosimetry. 1-Octanol was determined to provide sharp bed edge formation and relatively low flow resistance by photopatterning relative to other porogenic solvents. Compared with literature formulations which did not achieve good flow stability and reproducibility from batch to batch, using 2-hydroxyethyl methacrylate, ethylene dimethacrylate and 1-octanol as porogenic solvents, less than 4% RSD was achieved in flow stability over 7 days for monoliths prepared with 60-80% crosslinker(monomer+crosslinker) ratio. Column-to-column variation of 5% RSD was obtained in this composition range. These results demonstrate that photopatterning of uniform polymer monolithic beds, which is critical for applications in multiplexed microfluidic systems, requires careful attention to the parameters that affect reproducibility, specifically the porogenic solvent choice and the crosslinker to monomer ratio.