Related Experiment Video

Updated: Jun 11, 2026

Experimental Methods to Study Human Postural Control
08:12

Experimental Methods to Study Human Postural Control

Published on: September 11, 2019

Study of intra-subject random variations of stabilometric parameters

Pierre-Marie Gagey, Bernard Weber

    Medical & Biological Engineering & Computing
    |June 29, 2010
    PubMed

    More Related Videos

    A Vibrotactile Feedback Device for Seated Balance Assessment and Training09:13

    A Vibrotactile Feedback Device for Seated Balance Assessment and Training

    Published on: January 20, 2019

    Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior10:52

    Simulation of Human-induced Vibrations Based on the Characterized In-field Pedestrian Behavior

    Published on: April 13, 2016

    Related Concept Videos

    Variation01:19

    Variation

    An important characteristic of any set of data is the variation in the data. In some data sets, the data values are concentrated closely near the mean; in other data sets, the data values are more widely spread out from the mean. The most common measure of variation, or spread, is the standard deviation, which is the square root of variance.
    When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
    Uncertainty in Measurement: Accuracy and Precision03:37

    Uncertainty in Measurement: Accuracy and Precision

    Scientists typically make repeated measurements of a quantity to ensure the quality of their findings and to evaluate both the precision and the accuracy of their results. Measurements are said to be precise if they yield very similar results when repeated in the same manner. A measurement is considered accurate if it yields a result that is very close to the true or the accepted value. Precise values agree with each other; accurate values agree with a true value.
    Random Error01:04

    Random Error

    Random or indeterminate errors originate from various uncontrollable variables, such as variations in environmental conditions, instrument imperfections, or the inherent variability of the phenomena being measured. Usually, these errors cannot be predicted, estimated, or characterized because their direction and magnitude often vary in magnitude and direction even during consecutive measurements. As a result, they are difficult to eliminate. However, the aggregate effect of these errors can be...
    Random and Systematic Errors01:20

    Random and Systematic Errors

    Scientists always try their best to record measurements with the utmost accuracy and precision. However, sometimes errors do occur. These errors can be random or systematic. Random errors are observed due to the inconsistency or fluctuation in the measurement process, or variations in the quantity itself that is being measured. Such errors fluctuate from being greater than or less than the true value in repeated measurements. Consider a scientist measuring the length of an earthworm using a...
    Application of Linearization and Approximation01:29

    Application of Linearization and Approximation

    A drone flying through complex terrain often relies on more than one sensing method to estimate small changes in altitude. Along with direct measurements, air pressure provides a useful indirect indicator of vertical movement. Atmospheric pressure decreases as altitude increases, and this relationship is commonly described using an exponential model. Although accurate, converting pressure measurements into altitude values requires calculations that are too complex to perform repeatedly during...