Bilateral contact ground reaction forces and contact times during plyometric drop jumping

Nick B Ball1, Christopher G Stock, Joanna C Scurr

  • 1National Institute of Sports Studies, University of Canberra, Bruce, Australia. nick.ball@canberra.edu.au

Related Concept Videos

Static and Kinetic Frictional Force01:05

Static and Kinetic Frictional Force

One of the simpler characteristics of sliding friction is that it is parallel to the contact surfaces between systems, and is always in a direction that opposes the motion or attempted motion of the systems relative to each other. If two systems are in contact and moving relative to one another, then the friction between them is called kinetic friction. For example, kinetic friction slows a hockey puck sliding on ice.
However, if two systems are in contact and are stationary relative to one...
Impulse-Momentum Theorem00:49

Impulse-Momentum Theorem

The total change in the motion of an object is proportional to the total force vector acting on it and the time over which it acts. This product is called impulse, a vector quantity with the same direction as the total force acting on the object.
By writing Newton's second law of motion in terms of the momentum of an object and the external force acting on it, and simultaneously using the definition of the impulse vector, it can be shown that the total impulse on an object is equal to its net...
Free-falling Bodies: Introduction01:07

Free-falling Bodies: Introduction

All objects, neglecting air resistance, fall with the same acceleration towards the Earth's center due to the force exerted by the Earth's gravity. This experimentally determined fact is unexpected because we are so accustomed to the effects of air resistance and friction that we expect light objects to fall slower than heavier ones. People believed that a heavier object had a greater acceleration when falling until Galileo Galilei (1564–1642) proved otherwise. We now know this is not the case.
Free-falling Bodies: Example01:05

Free-falling Bodies: Example

An object falling without any air resistance under the influence of gravitational force is said to be in free-fall. For free-falling bodies, the acceleration due to gravity is constant, irrespective of their mass. Free-fall is experienced not only by objects falling downward, but also by all objects whose motion is influenced by gravitational force alone. The dynamics of free-fall motion can be calculated using kinematic equations of motion, since free-fall acceleration is constant.
The...
Impact: Problem Solving01:26

Impact: Problem Solving

In an experiment conducted during a Mars mission, a rover propels a projectile with an initial velocity, and the projectile rebounds after colliding with the Martian surface. To ascertain the maximum height attained by the projectile after this collision, the known restitution coefficient and acceleration due to gravity are employed.
By designating the launch point as the origin and utilizing kinematic equations, the vertical component of the projectile's velocity at the point of impact is...
Dry Friction01:30

Dry Friction

Dry friction occurs between two solid surfaces in contact as they attempt to move relative to one another. In daily life, dry friction is encountered in various forms, such as when walking on the ground, sliding an object across a table, or rubbing hands together. Despite its ubiquity, the underlying mechanisms behind dry friction are not readily visible.
To illustrate this concept, imagine a wooden crate resting on a rough, non-uniform horizontal surface. When an external force is applied to...