Related Experiment Video
Updated: Jun 11, 2026

Cortical Bone Assessment Using Ultrasonic Guided Waves: A Reproducibility Study in a Healthy Population
Published on: January 31, 2025
Ultrasonic wave propagation in cementitious materials: a multiphase approach of a self-consistent multiple scattering
M Molero1, I Segura, M G Hernández
1CAEND - CSIC/UPM, 28500 Arganda del Rey, Madrid, Spain. molero@caend.upm-csic.es
Abstract:
This paper examines ultrasonic wave propagation through strongly heterogeneous materials such as cementitious materials, and deals meanly with the formulation of a multiphase approach of a self-consistent multiple scattering model, the so-called dynamic generalized self-consistent model (DGSCM) proposed by Yang [J. Appl. Mech. 70(2003) 575-582]. This extended model can describe the influence of the size and volume fraction of aggregates on cementitious materials, as well as the interaction, contribution, and influence of entrapped air voids together with the aggregates on frequency-dependent parameters such as the phase velocity and the attenuation coefficient. To show the performance of this approach, theoretical predictions were compared with experimental ultrasonic measurements over a wide frequency range from several mortar specimens with different features in their microstructure properties and concentrations of aggregates up to 60%. The multiphase approaches of both the DGSCM and the Waterman-Truell model (WT) were also compared. The obtained results of the multiphase DGSCM were found to be significantly better than those obtained from the N-phase WT model for ultrasonic measurements from cementitious materials at high aggregate concentrations. The feasibility of material characterization using the multiphase approach of DGSCM was also discussed.
Related Concept Videos
Porosity in Cement Paste
The balance of water to cement in the mix is critical—it...
Permeability of Concrete
Propagation of Waves
Consider a scenario where a wave propagates from a string of low linear mass density to a string of high linear mass density. In such a case, the reflected wave is out of phase with respect to the incident wave, however the...
Microcracking in Concrete
Soundness of Cement
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...

