Fiber diameters control osteoblastic cell migration and differentiation in electrospun gelatin

Defined electrospinning conditions were used to create scaffolds with different fiber diameters to investigate their interactions with osteoblastic MG63 cells. Nonwoven gelatin scaffolds were electrospun with varied fiber diameters to investigate the effect of fiber size and resultant porosity on cell proliferation, viability, migration, and differentiation. The low toxicity solvent acetic acid:ethyl acetate:water ratio and gelatin concentrations were optimized to create small and large diameter fibers. The fiber diameters obtained by this procedure were 110 +/- 40 nm for the small and 600 +/- 110 nm for the large fibers. Cell viability assays showed that MG63 cells grew similarly on both fibers at the early time point (day 3) but preferred the scaffold with large diameter fibers by the later time points (day 5 and day 7). Confocal microscopic imaging showed that MG63 cells migrated poorly (maximum depth of 18 microm) into the scaffold of small diameter fibers, but readily penetrated (maximum depth of 50 microm) into the scaffold of large diameter fibers. Alkaline phosphatase (ALP) assays showed that MG63 cells differentiated on scaffolds made from both diameter fibers. In longer term experiments, MG63 cells differentiated to a greater extent on scaffolds made from small diameter fibers compared to large diameter fibers at days 3 and 7, but the ALP levels were the same for both diameter fibers by day 14. These results indicate that cells can perceive differences in the diameter and resultant pore size of electrospun gelatin fibers and that they process this information to alter their behavior.