Related Experiment Video

Updated: Jun 10, 2026

Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere
08:52

Near-Infrared Temperature Measurement Technique for Water Surrounding an Induction-heated Small Magnetic Sphere

Published on: April 30, 2018

Effect of spatial noise on the minimum resolvable temperature of a staring sensor

J M Mooney

    Applied Optics
    |August 14, 2010
    PubMed

    More Related Videos

    Subsurface Defect Localization by Structured Heating Using Laser Projected Photothermal Thermography11:34

    Subsurface Defect Localization by Structured Heating Using Laser Projected Photothermal Thermography

    Published on: May 15, 2017

    Related Concept Videos

    Difference from Background: Limit of Detection01:05

    Difference from Background: Limit of Detection

    The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
    The LOD indicates the presence or absence...
    Atomic Spectroscopy: Effects of Temperature01:27

    Atomic Spectroscopy: Effects of Temperature

    Atomization, converting samples into gas-phase atoms and ions, is essential for atomic spectroscopy. The flame temperature required for atomization affects the efficiency of the atomic spectroscopic methods by increasing the atomization efficiency and the relative population of the excited and ground states.
    At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature from...