Related Experiment Video

Updated: Jun 9, 2026

Development of Whispering Gallery Mode Polymeric Micro-optical Electric Field Sensors
08:32

Development of Whispering Gallery Mode Polymeric Micro-optical Electric Field Sensors

Published on: January 29, 2013

Effect of field regeneration on the TEM(00) transmission characteristics of a circular-section waveguide

R M Jenkins, R W Devereux

    Applied Optics
    |August 25, 2010
    PubMed

    More Related Videos

    Terahertz Microfluidic Sensing Using a Parallel-plate Waveguide Sensor07:28

    Terahertz Microfluidic Sensing Using a Parallel-plate Waveguide Sensor

    Published on: August 30, 2012

    Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials10:35

    Using Microwave and Macroscopic Samples of Dielectric Solids to Study the Photonic Properties of Disordered Photonic Bandgap Materials

    Published on: September 26, 2014

    Related Concept Videos

    Propagation Speed of Electromagnetic Waves01:30

    Propagation Speed of Electromagnetic Waves

    Electromagnetic waves are consistent with Ampere's law. Assuming there is no conduction current Ampere's law is given as:
    Transmission Line Design Considerations01:23

    Transmission Line Design Considerations

    Aluminum has become the material of choice for overhead transmission lines, surpassing copper due to its abundance and cost-effectiveness. The most prevalent type is the aluminum conductor, steel-reinforced (ACSR), which combines aluminum strands around a steel core. Other variants include all-aluminum conductors (AAC), all-aluminum alloy conductors (AAAC), aluminum conductor alloy-reinforced (ACAR), and aluminum-clad steel conductors. Advanced designs, such as aluminum conductors with steel...
    Boundary Conditions: Lossless Lines01:21

    Boundary Conditions: Lossless Lines

    Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
    At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
    Generating Electromagnetic Radiations01:10

    Generating Electromagnetic Radiations

    The German physicist Heinrich Hertz (1857–1894) was the first to generate and detect certain types of electromagnetic waves in the laboratory. Starting in 1887, he performed a series of experiments that confirmed the existence of electromagnetic waves and verified that they travel at the speed of light. Hertz used an alternating-current RLC (resistor-inductor-capacitor) circuit that resonated at a known frequency and connected it to a loop of wire. High voltages induced across the gap in the...
    Lossless Lines01:23

    Lossless Lines

    In electrical engineering, a lossless transmission line is characterized by a purely imaginary propagation constant and a resistive characteristic impedance. The ABCD parameters, which describe the relationship between the input and output voltages and currents, indicate an equivalent π circuit with an imaginary series impedance and a shunt admittance. This results in a transmission line that, when the product of the phase constant (beta) and the length of the line is less than pi, exhibits...
    Traveling Waves: Lossless Lines01:27

    Traveling Waves: Lossless Lines

    The provided content explores the behavior of traveling waves on single-phase lossless transmission lines. It begins with a single-phase two-wire lossless transmission line of length Δx, characterized by a loop inductance LH/m and a line-to-line capacitance C F/m. These parameters result in a series inductance LΔx and a shunt capacitance CΔx.