Related Experiment Video
Updated: Jun 9, 2026

Effectiveness of the Air Stripping in Two Salmonid Fish, Rainbow Trout (Oncorhynchus Mykiss) and Brown Trout (Salmo Trutta Morpha fario)
Published on: September 16, 2018
Effect of spawning number and ration on reproductive performance of the batch-spawning three-spined stickleback
1Institute of Biological, Environmental and Rural Sciences, Aberystwyth University, Aberystwyth, SY23 3DA, Wales, UK. rjw@aber.ac.uk
Abstract:
An experiment quantified the effect of food ration and spawning number on the breeding season reproductive performance of batch-spawning, female three-spined sticklebacks Gasterosteus aculeatus. Individually housed females were maintained on fixed rations of 2, 4, 8 or 16% of their initial postspawning mass of live enchytraeid worms from immediately after their first spawning until they ceased spawning. Number of spawnings correlated positively with ration. Total breeding season reproductive investment (total wet mass of eggs produced as a percentage of initial postspawning female mass) ranged from 38% at the 2% ration to 147% at the 16% ration. At the lower rations, postspawning mass, batch fecundity and wet and dry masses of the batch declined over successive spawnings, with the rate of decline inversely related to ration. At the highest ration, there was no decline in batch fecundity and postspawning mass increased over successive spawnings. Mean reproductive investment per inter-spawning interval was higher at the highest ration, but at all rations declined over successive spawnings. Mean reproductive effort per inter-spawning interval (wet mass of eggs spawned as a percentage of the wet mass of food consumed over the inter-spawning interval) was inversely related to ration. At the higher rations, reproductive effort showed no trend over successive spawnings. Neither spawning number nor ration had a systematic effect on egg diameter, wet mass per egg, dry mass per egg or total lipid content of the eggs. If the rate of food intake was insufficient, although batch fecundity declined, the main adjustment was a reduction in the number of spawnings in the breeding season.
Related Concept Videos
Testing a Claim about Mean: Known Population SD
Estimating a population mean requires the samples to be distributed normally. The data should be collected from the randomly selected samples having no sampling bias. The sample size needed to be higher than 30, and most importantly, the population standard deviation should be already known.
In most realistic situations, the population standard deviation is often unknown, but in rare circumstances, when it...
Fixed Action Patterns
Testing a Claim about Population Proportion
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Energy Budgets and Reproductive Strategies

