Related Experiment Video

Updated: Jul 31, 2026

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability
09:23

Removal of Trace Elements by Cupric Oxide Nanoparticles from Uranium In Situ Recovery Bleed Water and Its Effect on Cell Viability

Published on: June 21, 2015

[Volume reduction and tritium retention factor in electrolytic enrichment of water]

E Hirai1, N Matsuoka, Y Takashima

  • 1Kyushu Environmental Evaluation Association, Fukuoka-shi, Japan.

Radioisotopes
|November 1, 1990
PubMed

More Related Videos

Speciation and Bioavailability Measurements of Environmental Plutonium Using Diffusion in Thin Films12:22

Speciation and Bioavailability Measurements of Environmental Plutonium Using Diffusion in Thin Films

Published on: November 9, 2015

Separation of Uranium and Thorium for 230Th-U Dating of Submarine Hydrothermal Sulfides08:43

Separation of Uranium and Thorium for 230Th-U Dating of Submarine Hydrothermal Sulfides

Published on: May 20, 2019

Related Concept Videos

Electrolytes: van't Hoff Factor03:08

Electrolytes: van't Hoff Factor

Colligative Properties of ElectrolytesThe colligative properties of a solution depend only on the number, not on the identity, of solute species dissolved. The concentration terms in the equations for various colligative properties (freezing point depression, boiling point elevation, osmotic pressure) pertain to all solute species present in the solution. Nonelectrolytes dissolve physically without dissociation or any other accompanying process. Each molecule that dissolves yields one dissolved...
Factors Affecting Solubility04:01

Factors Affecting Solubility

Compared with pure water, the solubility of an ionic compound is less in aqueous solutions containing a common ion (one also produced by dissolution of the ionic compound). This is an example of a phenomenon known as the common ion effect, which is a consequence of the law of mass action that may be explained using Le Chȃtelier’s principle. Consider the dissolution of silver iodide:
Electrolysis03:00

Electrolysis

In a galvanic cell, the electrical work is done by a redox system on its surroundings as electrons produced by the spontaneous redox reactions are transferred through an external circuit. Alternatively, an external circuit does work on a redox system by imposing a voltage sufficient to drive an otherwise nonspontaneous reaction in a process known as electrolysis. For instance, recharging a battery involves the use of an external power source to drive the spontaneous (discharge) cell reaction in...
Masking and Demasking Agents01:19

Masking and Demasking Agents

EDTA titrations may necessitate masking and demasking agents to temporarily protect a particular metal ion in a mixture from the EDTA reaction. These agents facilitate the sequential analysis of the metal ions by forming stable complexes with some—but not all—metal ions during certain steps.
There are many masking agents, such as cyanide, fluoride, triethanolamine, thiourea, and 2,3-bis(sulfanyl)propan-1-ol (formerly 2,3-dimercapto-1-propanol), with the masking agent chosen based on the metal...
Washing, Drying, and Ignition of Precipitates00:52

Washing, Drying, and Ignition of Precipitates

After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
Ostwald’s Dilution Law01:25

Ostwald’s Dilution Law

Consider a binary electrolyte AB with a concentration ‘c’ that reversibly dissociates into its constituent ions. The degree of this dissociation is represented by ⍺. This means that the equilibrium concentration of each ionic species can be expressed as ⍺c. As well as this, the fraction of the electrolyte that remains undissociated at equilibrium is given by (1−⍺). The corresponding equilibrium concentration for this undissociated portion is then calculated as (1−⍺)c. For such solutions,...