Electric-field assisted immobilization and hybridization of DNA oligomers on thin-film microchips

Single, square voltage pulses in the microsecond timescale result in selective 5'-end covalent bonding (immobilization) of thiolated single-stranded (ss) DNA probes to a modified silicon dioxide flat surface and in specific hybridization of ssDNA targets to the immobilized probe. Immobilization and hybridization rates using microsecond voltage pulses at or below 1 V are at least 10(8) times faster than in the passive control reactions performed without electric field (E), and can be achieved with at least three differently functionalized thin-film surfaces on plastic or glass substrates. The systematic study of the effect of DNA probe and target concentrations, of DNA probe and target length, and the application of asymmetric pulses on E-assisted DNA immobilization and hybridization showed that: (1) the rapidly rising edge of the pulse is most critical to the E-assisted processes, but the duration of the pulse is also important; (2) E-assisted immobilization and hybridization can be performed with micrometre-sized pixels, proving the potential for use on microelectronic length scales, and the applied voltage can be scaled down together with the electrode spacing to as low as 25 mV; and (3) longer DNA chains reduce the yield in the E-assisted immobilization and hybridization because the density of physisorbed single-stranded DNA is reduced. The results show that the E-induced reactions can be used as a general method in DNA microarrays to produce high-density DNA chips (E-immobilization) and speed the microarray-based analysis (E-hybridization).