Related Experiment Video

Updated: Jun 8, 2026

Single Molecule Fluorescence Microscopy on Planar Supported Bilayers
20:00

Single Molecule Fluorescence Microscopy on Planar Supported Bilayers

Published on: October 31, 2015

Compact dielectric reflective elements. II. Multichannel filter of closely spaced spectral bands

J Spigulis, J Lazdins

    Applied Optics
    |October 14, 2010
    PubMed

    More Related Videos

    X-ray Beam Induced Current Measurements for Multi-Modal X-ray Microscopy of Solar Cells10:16

    X-ray Beam Induced Current Measurements for Multi-Modal X-ray Microscopy of Solar Cells

    Published on: August 20, 2019

    Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters15:25

    Design and Characterization Methodology for Efficient Wide Range Tunable MEMS Filters

    Published on: February 4, 2018

    Related Concept Videos

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation01:26

    Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation

    Inductively coupled plasma (ICP) is the common plasma source used in atomic emission spectroscopy (AES), a technique that detects and analyzes various elements in a sample. This method is often called inductively coupled plasma atomic emission spectroscopy (ICP-AES).
    There are three main types of inductively coupled plasma atomic emission spectroscopy  (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used.
    Active Filters01:25

    Active Filters

    Active filters are electronic circuits that use operational amplifiers (op-amps), resistors, and capacitors to filter out unwanted frequency components from a signal. A first-order low-pass active filter is designed to pass signals with a frequency lower than a certain cutoff frequency and attenuate frequencies higher than that cutoff frequency. The transfer function for a first-order low-pass active filter is:
    Passive Filters01:27

    Passive Filters

    Passive filters are utilized to shape the frequency spectrum of signals across a diverse array of applications. These filters, using only passive elements like resistors (R), inductors (L), and capacitors (C), are capable of selectively allowing or blocking certain frequency ranges without the need for external power sources.
    Low-Pass Filters
    Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff frequency...
    Clipper Circuit01:18

    Clipper Circuit

    A clipper circuit is a fundamental wave-shaping device that harnesses the unique properties of diodes to alter and control waveform characteristics. This technology is widely used in electronic devices, especially in television and radar communication systems, where it enhances waveform modulation in both transmitters and receivers.
    The operation of a clipper circuit can be exemplified by analyzing a dual-clipper configuration setup that integrates two ideal diodes, each paired with a biasing...
    Design Example01:23

    Design Example

    The innovation of touch-tone telephony revolutionized the telecommunications industry by replacing the traditional rotary dial with a dual-tone multi-frequency (DTMF) signaling system. This system uses a matrix-style keypad with buttons arranged in four rows and three columns, creating 12 distinct signals each assigned to a pair of frequencies. Each button press results in a simultaneous generation of two sinusoidal tones – one from a low-frequency group (697 to 941 Hz) and one from a...
    Parallel Resonance01:23

    Parallel Resonance

    The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by: