Related Experiment Video
Updated: Jun 8, 2026

The HoneyComb Paradigm for Research on Collective Human Behavior
Published on: January 19, 2019
A theoretical investigation on the honeycomb potential fluid
1State Key Laboratory of Powder Metallurgy, Central South University, Changsha, Hunan 410083, China. chixiayzsq@yahoo.com
Abstract:
A local self-consistent Ornstein-Zernike (OZ) integral equation theory (IET) is proposed to provide a rapid route for obtaining thermodynamic and structural information for any thermodynamically stable or metastable state points in the bulk phase diagram without recourse to traditional thermodynamic integration, and extensive NVT-Monte Carlo simulations are performed on a recently proposed honeycomb potential in three dimensions to test the theory's reliability. The simulated quantities include radial distribution function (rdf) and excess internal energy, pressure, excess chemical potential, and excess Helmholtz free energy. It is demonstrated that (i) the theory reproduces the rdf very satisfactorily only if the bulk state does not enter deep into a two phases coexistence region; (ii) the excess internal energy is the only one of the four thermodynamic quantities investigated amenable to the most accurate prediction by the present theory, and the simulated pressure is somewhat overestimated by the theoretical calculations, but the deviation tends to vanish along with rising of the temperature; (iii) using the structural functions from the present local self-consistent OZ IET, a previously derived local expression, due to the present author, achieves even a higher accuracy in calculating for the excess chemical potential than the exact virial pressure formula for the pressure, and the resulting excess Helmholtz free energy is in surprisingly same with the simulation results due to offset of the errors. Based on the above observations, it is suggested that it may be a good procedure to integrate the theoretical excess internal energy along the isochors to get the excess Helmholtz free energy, which is then fitted to a polynomial to be used for calculation of all of other thermodynamic quantities in the framework of the OZ IET.
More Related Videos
09:20Microhoneycomb Monoliths Prepared by the Unidirectional Freeze-drying of Cellulose Nanofiber Based Sols: Method and Extensions
Published on: May 24, 2018
10:23A Computational Modeling Approach to Investigate the Influence of Hyperthermia on the Tumor Microenvironment
Published on: December 1, 2023
Related Concept Videos
Capillarity in Fluid
Surface tension is crucial to capillarity. It results from cohesive forces between liquid molecules at the liquid-air boundary, forming a skin that resists external forces. When the capillary tube...
Viscosity
The SI unit of viscosity is...
Characteristics of Fluids
Characteristics of Fluids
Fluids, which include both liquids and gases, are substances that deform continuously under shearing stress. For example, water and oil are liquids with molecules that can...
Plane Potential Flows
Uniform Flow
Uniform flow...
Accelerating Fluids
The motion of the liquid within this infinitesimal cylinder is considered to obtain the pressure difference. Three vertical forces act on this liquid: