Related Experiment Video
Updated: Jun 7, 2026

A Novel Bioreactor for High Density Cultivation of Diverse Microbial Communities
Published on: December 25, 2015
The role of loading rate, backwashing, water and air velocities in an up-flow nitrifying tertiary filter
Emmanuelle Vigne1, Jean-Marc Choubert, Jean-Pierre Canler
1Civil and Water Engineering Department, Faculty of Sciences and Engineering, Pavillon Adrien-Pouliot, Laval University, Quebec, Canada G1K 7P4.
Abstract:
The vertical distribution of nitrification performances in an up-flow biological aerated filter operated at tertiary nitrification stage is evaluated in this paper. Experimental data were collected from a semi-industrial pilot-plant under various operating conditions. The actual and the maximum nitrification rates were measured at different levels inside the up-flow biofilter. A nitrogen loading rate higher than 1.0 kg NH4-Nm(-3)_mediad(-1) is necessary to obtain nitrification activity over all the height of the biofilter. The increase in water and air velocities from 6 to 10 m h(-1) and 10 to 20 m h(-1) has increased the nitrification rate by 80% and 20% respectively. Backwashing decreases the maximum nitrification rate in the media by only 3-14%. The nitrification rate measured at a level of 0.5 m above the bottom of the filter is four times higher than the applied daily average volumetric nitrogen loading rate up to 1.5 kg NH4-N m(-3)_mediad(-1). Finally, it is shown that 58% of the available nitrification activity is mobilized in steady-state conditions while up to 100% is used under inflow-rate increase.
Related Concept Videos
Microbial Wastewater Treatment
Biological Treatment of Effluent and Waste Water
Microbes and the Nitrogen Cycle
Bioreactor Controls-II
Filtration
Freshwater Microbial Ecology

