Studies in organic peroxides; molecular refractivity and the structure of organic peroxides

Diols are compounds with two hydroxyl groups. In addition to syn dihydroxylation, diols can also be synthesized through the process of anti dihydroxylation. The process involves treating an alkene with a peroxycarboxylic acid to form an epoxide. Epoxides are highly strained three-membered rings with oxygen and two carbons occupying the corners of an equilateral triangle. This step is followed by ring-opening of the epoxide in the presence of an aqueous acid to give a trans diol.

In the presence of organic peroxides, the addition of hydrogen bromide to an alkene yields the isomer that is not predicted by Markovnikov’s rule. For example, the addition of hydrogen bromide to 2-methylpropene in the presence of peroxides gives 1-bromo-2-methylpropane. This addition reaction proceeds via a free radical mechanism, which reverses the regioselectivity. The free radical reaction mechanism involves three stages: initiation, propagation, and termination.

One of the critical aspects of the E1 reaction mechanism, as also observed in E2, is the regiochemistry, with multiple regioisomers obtained as products. In the example discussed, the presence of water as a weak base favors elimination over substitution to generate two alkenes. Given that alkenes’ stability increases with the number of alkyl groups across the double bond, typically, E1 reactions lead to the Zaitsev product, for this is more substituted and stable than the Hofmann product.

Elimination reactions of alkyl halides can yield one or more alkenes depending on the specific regiochemical and stereochemical considerations. While the regiochemistry of the reaction governs the location of the double bond in the product, the stereochemical requirements often influence the geometry.
When a substrate with two different β hydrogens undergoes an E2 elimination, the presence of a strong base can yield two regioisomeric alkenes. The more-substituted alkene is the major product and...

Ideally, an unpaired electron shows a single peak in the EPR spectrum due to the transition between the two spin energy states. However, coupling interactions can occur between the spins of the unpaired electron and any neighboring spin-active nuclei. This hyperfine coupling results in hyperfine splitting, where the EPR signal is split into multiplets. The signals split into 2nI + 1 peaks, where n is the number of equivalent nuclei and I is the nuclear spin. These splitting patterns provide...

An acid can be deprotonated to form a conjugate base or an anion. If the produced anion is more stable, then the acid is stronger. On the contrary, if the anion is unstable, then the acid is weaker. Hence, to determine the acidity of the compound, the stability of its conjugate base is studied using various factors.
The size effect explains the change in atomic size on acidity. When comparing the acids formed from elements that belong to the same column in the periodic table, their atomic sizes...