The effect of morphine on dye concentration curves for plasma volume determination in dogs

Pharmacodynamics explores the relationship between drug concentration and its effect. In a quantal response drug, the duration of action better correlates with drug concentration, while for graded effect drugs, the intensity of response is more relevant. This intensity depends on the dose, drug removal rate, and the region of the concentration–response curve.The concentration–response curve can be divided into three regions. Region 3 (80–100% maximum response) demonstrates that even as drug...

A drug’s dosage and pharmacokinetic properties determine how quickly it acts, how intense its effects are, and how long it lasts. Higher doses increase drug concentration at receptor sites, producing a hyperbolic curve when pharmacologic response is plotted against drug dose. Converting this scale to a log-linear format results in a sigmoidal curve, better representing dose–response relationships.For drugs following a one-compartment model, the pharmacologic response is directly proportional to...

For drugs producing a quantal response, onset occurs when plasma concentration reaches a minimum effective level (Cmin). The drug's action duration depends on how long the plasma concentration remains above Cmin.Two primary factors influence this duration: dose size and the rate of drug removal from the action site. Both depend on the drug's redistribution to poorly perfused tissues and elimination processes. A larger dose promotes rapid onset and prolongs the effect's duration.Consider a...

The progression of a drug's impact can be analyzed by examining both the concentration-time course and the effect-time course. The concentration-time course is determined by the drug's half-life and is influenced by factors such as its pharmacokinetics, including absorption, distribution, metabolism, and elimination. The effect of the drug is often related to its concentration in the plasma and is calculated using the maximum drug effect and the plasma concentration that generates 50 percent of...

The linear concentration–effect model, underpinned by the principle that pharmacological effect (E) is directly proportional to plasma drug concentration (C), emerges as a pivotal simplification of the Emax model for conditions where C is significantly less than EC50. This model portrays a linear trajectory of the concentration–effect relationship when drug levels are markedly below the EC50 threshold.Despite its inherent assumption of continuous effect augmentation with increasing drug...

The log-linear model is a pharmacological framework used to describe the relationship between drug concentration and its effect. This model is particularly relevant when the observed effects range between 20% and 80% of the drug’s maximum effect (Emax), where a near-linear relationship is observed between the log of drug concentration and the measured effect. However, the log-linear model does not predict the maximum possible effect (Emax) or the effect at zero drug concentration, limiting its...