Related Experiment Video
Updated: Jun 7, 2026

Proof-of-Concept for Gas-Entrapping Membranes Derived from Water-Loving SiO2/Si/SiO2 Wafers for Green Desalination
Published on: March 1, 2020
Adsorption of nonionic surfactants (CnEm) at the silica-water and cellulose-water interface
Suprita K Singh1, Shannon M Notley
1Department of Applied Mathematics, Research School of Physics and Engineering, Australian National University, Canberra 0200 ACT, Australia.
Abstract:
The adsorption of nonionic surfactants to the silica-water and cellulose-water interfaces was studied using optical reflectometry (OR) and soft-contact atomic force microscopy imaging. The polyethylene oxide alkyl ethers C(14)E(6) and C(16)E(8) were shown to readily adsorb to both interfaces. The kinetics of the adsorption process as well as the equilibrium surface excess was determined using OR. In agreement with previous studies, the short headgroup surfactant C(14)E(6) adsorbed to a greater extent than the longer headgroup surfactant C(16)E(8) on silica. This trend was also observed for the cellulose-water interface. The structure of the adsorbed surfactant layer above the critical surface aggregation concentration (csac) was visualized using the soft contact imaging technique for both interfaces. On the silica surface, the layer structure for both surfactants mostly showed spherical aggregates, however, with some elongation into rods being more prevalent for C(14)E(6). Similar structures were observed on the cellulose surface, but imaging was more difficult due to the soft gel-like nature of the cellulose thin film in water. This suggests that these surfactants adsorb in a cooperative fashion above the critical micelle concentration (cmc) with a similar interaction between surfactant headgroup and surface for both silica and cellulose. No evidence was seen for the penetration of surfactant molecules into the cellulose surface or any solubilization of the interface.
Related Concept Videos
Micelles
Surface Active Agents
Colloids
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules, atoms, and/or ions)...
Intermolecular Forces
Capillary Electrophoresis: Applications
Capillary zone electrophoresis (CZE) separates ionic components based on their electrophoretic mobility. It has been used to separate proteins, amino acids,...

