Effect of wood properties on within-tree variation in ultrasonic wave velocity in softwood

Masumi Hasegawa1, Masato Takata, Junji Matsumura

  • 1Department of Agro-Environmental Science, Faculty of Agriculture, Kyushu Univ., 6-10-1 Hakozaki, Higashi-ku, Fukuoka 812-8581, Japan. kmgtmsm@agr.kyushu-u.ac.jp

Ultrasonics
|November 3, 2010
PubMed

Related Concept Videos

Softwoods and Hardwoods01:28

Softwoods and Hardwoods

Softwoods and hardwoods, derived from different types of trees, are distinguished by their leaf structures and cellular compositions, each serving unique purposes in construction and manufacturing. Softwoods come from cone-bearing trees with needle-like leaves and are predominantly composed of longitudinal cells called tracheids and a smaller proportion of radial cells known as rays. Due to their cellular structure, softwoods are commonly used in construction for structural frames, sheathing,...
Structural Properties and Dimensions of Lumber01:21

Structural Properties and Dimensions of Lumber

Wood's structural properties derive from fibers aligned along the tree's length, contributing significantly to its mechanical strength. Wood exhibits up to twenty times greater tensile strength along these fibers compared to across them, and generally shows better performance under compression than tension. The length of fibers varies, with hardwoods having fibers around one twenty-fifth inch long and softwoods ranging from one-eighth to one-third inch.
The strength characteristics of wood are...
Introduction to Wood01:19

Introduction to Wood

Wood, derived from trees, is a versatile and widely used construction material. Trees feature a trunk surrounded by a protective layer of dead bark. Beneath this outer layer lies the living bark, followed by the cambium, and then the sapwood which transitions into heartwood as it matures. At the center of the trunk is the pith. The age of a tree can be discerned by examining its growth rings, which are concentric bands visible in the trunk's cross-section.
The structural integrity of the wood...
Damped Oscillations01:07

Damped Oscillations

In the real world, oscillations seldom follow true simple harmonic motion. A system that continues its motion indefinitely without losing its amplitude is termed undamped. However, friction of some sort usually dampens the motion, so it fades away or needs more force to continue. For example, a guitar string stops oscillating a few seconds after being plucked. Similarly, one must continually push a swing to keep a child swinging on a playground.
Although friction and other non-conservative...
Lumber Defects01:23

Lumber Defects

Lumber defects, which can affect both the appearance and structural integrity of wood, include a variety of growth and manufacturing flaws. Growth defects such as knots and knotholes occur where branches were once attached to the tree trunk, with knotholes forming when these knots fall out. Other natural defects include decay and insect damage, which compromise the wood's strength and durability.
Shakes are minor fractures that run along or across the wood's annual rings, while wane is...
Speed of Sound in Solids and Liquids00:51

Speed of Sound in Solids and Liquids

Most solids and liquids are incompressible—their densities remain constant throughout. In the presence of an external force, the molecules tend to restore to their original positions, which is only possible because the constituents interact. The interactions help the constituents pass on information about external disturbances, like sound waves. Therefore, sound waves travel faster through these media. Compared to solids, the constituents in a liquid are less tightly bound. Thus, sound waves...