Aberrations and convergence characteristics of a concentric-circular focusing grating coupler: analysis

Applied Optics
|November 10, 2010
PubMed

Related Concept Videos

Focusing of Light in the Eye01:16

Focusing of Light in the Eye

Light rays enter the eye through the cornea, a transparent dome-shaped tissue that is the eye's outermost layer. The cornea bends or refracts, light rays traveling to the pupil. The shape of the cornea determines how much of the light is bent and whether the image will be focused correctly on the retina at the back of the eye. Once the light has passed through both refraction layers, it converges into a single focal point onto a small area. This is where photoreceptors start transforming...
Geometry of Hyperbolas01:30

Geometry of Hyperbolas

A hyperbola consists of all points where the absolute difference of distances to two fixed points, called foci, remains constant. The standard equation isEach branch extends infinitely and approaches two asymptotes, which guide the curve’s behavior. The parameters a and b define key features: a measures the distance from the center to each vertex along the transverse axis, while b influences the slopes of the asymptotes. The asymptotes have equationsA rectangle centered at the origin with...
Interference and Diffraction02:18

Interference and Diffraction

Interference is a characteristic phenomenon exhibited by waves. When two electromagnetic waves interact with their peaks and troughs coinciding, a resulting wave with enhanced amplitude is produced. This is known as constructive interference. In this case, the two waves interacting are in phase with each other.
Stress Concentrations in Circular Shafts01:18

Stress Concentrations in Circular Shafts

Consider the elastic torsion formula, which applies to a circular shaft with a consistent cross-section. This formula assumes that the shaft's ends are loaded with rigid plates firmly attached. However, in many cases, torques are applied to the shaft through mechanisms like flange couplings or gears, which are connected by keys inserted into keyways. This application method modifies the stress distribution near the point of torque application, causing it to deviate from the distributions...
Circular Shaft - Stresses in Linear Range01:13

Circular Shaft - Stresses in Linear Range

Consider a scenario where a circular shaft is subject to torque that remains within the boundaries of Hooke's Law, avoiding any permanent deformation. So, the formula for shearing strain is revisited. This formula is multiplied by the modulus of rigidity, and then Hooke's Law for the shearing stress and strain is applied. As a result, the equation for shearing stress in a shaft can be derived.
Gauss's Law: Cylindrical Symmetry01:20

Gauss's Law: Cylindrical Symmetry

A charge distribution has cylindrical symmetry if the charge density depends only upon the distance from the axis of the cylinder and does not vary along the axis or with the direction about the axis. In other words, if a system varies if it is rotated around the axis or shifted along the axis, it does not have cylindrical symmetry. In real systems, we do not have infinite cylinders; however, if the cylindrical object is considerably longer than the radius from it that we are interested in,...