Heat stability of reconstituted, protein-standardized skim milk powders

We determined the effects of standardization material, protein content, and pH on the heat stability of reconstituted milk made from low-heat (LH) and medium-heat (MH) nonfat dry milk (NDM). Low-heat and MH NDM were standardized downward from 35.5% to 34, 32, and 30% protein by adding either edible lactose powder (ELP) or permeate powder (PP) from skim milk ultrafiltration. These powders were called standardized skim milk powders (SSMP). The LH and MH NDM and SSMP were reconstituted to 9% total solids. Furthermore, subsamples of reconstituted NDM and SSMP samples were set aside to measure heat stability at native (unadjusted) pH, and the rest were adjusted to pH 6.3 to 7.0. Heat stability is defined as heat coagulation time at 140°C of the reconstituted LH or MH NDM and SSMP samples. The entire experiment was replicated 3 times at unadjusted pH values and 2 times at adjusted pH values. At an unadjusted pH, powder type, standardization material, and protein content influenced the heat stability of the samples. Heat stability for reconstituted LH NDM and SSMP was higher than reconstituted MH NDM and SSMP. Generally, decreased heat stability was observed in reconstituted LH or MH SSMP as protein content was decreased by standardization. However, adding ELP to MH SSMP did not significantly change its heat stability. When pH was adjusted to values between 6.3 and 7.0, powder type, standardization material, and pH had a significant effect on heat stability, whereas protein content did not. Maximum heat stability was noted at pH 6.7 for both reconstituted LH NDM and SSMP samples, and at pH 6.6 for both reconstituted MH NDM and SSMP samples. Furthermore, for samples with adjusted pH, higher heat stability was observed for reconstituted LH SSMP containing PP compared with reconstituted milk from LH SSMP containing ELP. However, no statistical difference was observed in the heat stability of reconstituted milk from MH NDM and MH SSMP samples. We conclude that powder type (LH or MH) and effect of standardization material (ELP or PP) can help explain differences in heat stability. The difference in the heat stability of powder type may be associated with the difference in the pH of maximum heat stability and compositional differences in the standardization material (ELP or PP).