1-Methyl-5-(4-methyl-phen-yl)-3-oxo-cyclo-hexane-1-carbonitrile

Naming Amides
The IUPAC and common names of amides are derived from the parent carboxylic acid, by replacing the suffix “oic acid” and “ic acid,” respectively, with “amide.” In the following example, the IUPAC name ethanamide is derived from ethanoic acid, and the common name, acetamide, is obtained from acetic acid.

Cycloalkanes are saturated cyclic hydrocarbons with carbon atoms arranged in the form of rings. They have two fewer hydrogen atoms than the corresponding acyclic alkane; therefore, their general formula is CnH2n. The structural formulas of cycloalkanes are simplified using the line-angle representation. The regular polygons are used to represent the cycloalkane rings, with each side representing a carbon-carbon bond.
The IUPAC nomenclature of cycloalkanes follows similar rules that apply to...

Depending upon the different spatial orientation of the substituents, the disubstituted cycloalkanes exhibit two types of stereoisomers. The cis isomers have the substituents on the same side of the ring, whereas the trans isomers have the substituents on the opposite sides. These stereoisomers exhibit different physical properties and cannot be interconverted without breaking the carbon-carbon bonds.
In cyclohexane, the substituents can occupy different positions generating distinct isomers.

Like aldehydes, ketones are named using IUPAC rules; in this case, by replacing “e” in the name of the longest hydrocarbon chain with “one.” In acyclic ketones, the ketonic carbon is given the lowest locant value. For instance, as shown below, a simple five-carbon ketone is named pentan-2-one, instead of pentan-4-one. IUPAC rules also allow the placing of the locant value before the parent name to give an alternate name, 2-pentanone.

Alkynes are unsaturated hydrocarbons characterized by the presence of carbon-carbon triple bonds and have a general formula CnH2n-2. The nomenclature of alkynes follows a set of rules similar to alkanes and alkenes; however, alkynes bear the suffix "-yne" instead of "-ane" or "-ene." There are two approaches to naming alkynes:

In mass spectrometry, cycloalkanes exhibit distinct fragmentation patterns due to the inherent stability of their molecular ions compared to linear or branched alkanes. The ring structure of cycloalkanes provides additional stability to the molecular ions, often resulting in prominent ion peaks in the mass spectrum.
For example, cyclohexane molecular ions have a mass-to-charge ratio (m/z) of 84, which tends to produce a stronger signal than linear alkanes like hexane. This stability comes from...