The effect of sodium fluoride on the stability of cyanide in postmortem blood samples from fire victims

Assigning a level of significance to cyanide concentrations found in the blood of fire victims is often hampered by the fact that cyanide is inherently unstable in cadavers and in stored blood samples. A few researchers have proposed that sodium fluoride can be used to minimize the instability of cyanide in blood samples; however, controlled studies have not been performed to support validation of this hypothesis. To test the sodium fluoride hypothesis, both treated and control blood samples from 14 autopsied fire victims were tested over a 25-30 day period. A 2% concentration of sodium fluoride was added to the blood samples at the start of testing and the samples were refrigerated between testing intervals. Cyanide concentrations in the treated and control samples were measured between 9 and 11 days post treatment and between 25 and 30 days post treatment. A statistically significant difference was not present between blood cyanide concentrations in treated and control samples between 9 and 11 days. During this time period, although there were small statistically significant increases in both treated and untreated samples the fluctuations were minor. Since the treated and control samples did not exhibit instability between 9 and 11 days, it is not surprising that the sodium fluoride appeared to have no effect. However, a statistically significant difference between blood cyanide concentrations in treated and control samples was observed between 25 and 30 days. Those samples treated with sodium fluoride showed a reduction in blood cyanide variability with virtually no overall change, over a 25-30 day period when compared to control samples, while unconditioned samples showed a significant, average increase of 35%. Based on the findings of this study, it is recommended that 2% sodium fluoride be added to blood samples obtained from fire victims to reduce cyanide instability due to bacteriological activity.