Related Experiment Video

Updated: Jun 4, 2026

Synthesis and Calibration of Phosphorescent Nanoprobes for Oxygen Imaging in Biological Systems
10:38

Synthesis and Calibration of Phosphorescent Nanoprobes for Oxygen Imaging in Biological Systems

Published on: March 3, 2010

Inter-laboratory calibration of new silver orthophosphate comparison materials for the stable oxygen isotope analysis

Stanislaw Halas1, Grzegorz Skrzypek, Wolfram Meier-Augenstein

  • 1Mass Spectrometry Laboratory, Institute of Physics, Marie Curie-Sklodowska University, Lublin, Poland. stanislaw.halas@umcs.lublin.pl

Rapid Communications in Mass Spectrometry : RCM
|February 4, 2011
PubMed

More Related Videos

Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method08:21

Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method

Published on: May 18, 2018

High-Throughput Measurement and Classification of Organic P in Environmental Samples08:58

High-Throughput Measurement and Classification of Organic P in Environmental Samples

Published on: June 8, 2011

Related Concept Videos

Photoluminescence: Applications01:14

Photoluminescence: Applications

Photoluminescence offers a wide range of applications due to its inherent sensitivity and selectivity. This technique allows for both direct and indirect analyses of the analyte. Direct quantitative analysis is possible when the analyte exhibits a favorable quantum yield for fluorescence or phosphorescence. However, an indirect analysis may be feasible if the analyte is not fluorescent or phosphorescent, or if the quantum yield is unfavorable. Indirect methods include reacting the analyte with...
Atomic Absorption Spectroscopy: Lab01:21

Atomic Absorption Spectroscopy: Lab

For AAS measurements, samples must be introduced as clear solutions, often requiring extensive preliminary treatment to dissolve materials like soils, animal tissues, and minerals. Common methods for sample preparation include treatment with hot mineral acids, wet ashing, combustion in closed containers, high-temperature ashing, or fusion with reagents.
 Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing nebulizer...
Flame Photometry: Lab01:16

Flame Photometry: Lab

In a flame photometer, when a solution like potassium chloride is aspirated into the flame, the solvent evaporates, leaving behind dehydrated salt. This salt dissociates into free gaseous atoms in their ground state. Some of these atoms absorb energy from the flame, leading to their excitation. The excited atoms return to the ground state, emitting photons at characteristic wavelengths. Because only electronic transitions are involved, the resulting emission lines are very narrow. The intensity...