Related Experiment Video

Updated: Jun 4, 2026

Synthesis of Ionic Liquid Based Electrolytes, Assembly of Li-ion Batteries, and Measurements of Performance at High Temperature
11:04

Synthesis of Ionic Liquid Based Electrolytes, Assembly of Li-ion Batteries, and Measurements of Performance at High Temperature

Published on: December 20, 2016

Density, viscosity and electrical conductivity of protic alkanolammonium ionic liquids

André Pinkert1, Keng L Ang, Kenneth N Marsh

  • 1Department of Chemical and Process Engineering, University of Canterbury, Christchurch, New Zealand.

Physical Chemistry Chemical Physics : PCCP
|February 8, 2011
PubMed

More Related Videos

Solid-state Graft Copolymer Electrolytes for Lithium Battery Applications05:33

Solid-state Graft Copolymer Electrolytes for Lithium Battery Applications

Published on: August 12, 2013

On-chip Isotachophoresis for Separation of Ions and Purification of Nucleic Acids10:32

On-chip Isotachophoresis for Separation of Ions and Purification of Nucleic Acids

Published on: March 2, 2012

Related Concept Videos

Basicity of Aliphatic Amines01:21

Basicity of Aliphatic Amines

Amines can behave as Brønsted–Lowry bases by accepting a proton from the acid to form corresponding conjugate acids. Due to a lone pair of nonbonding electrons, aliphatic amines can also act as Lewis bases by forming a covalent bond with an electrophile.
To measure the basicity of amines, two conventions are generally used. The first defines Kb as the basicity constant for the deprotonation reaction of water by the amine, as presented in Figure 1. Conventionally, lower Kb indicates higher...
Physical Properties of Alkanes02:33

Physical Properties of Alkanes

Alkanes are nonpolar molecules due to the presence of only carbon and hydrogen atoms. The electronegativity difference between carbon and hydrogen is minimal, and hence alkanes have a zero dipole moment. This leads to the presence of only dispersion forces between the molecules. The strength of dispersion forces is dependent on the surface area of the molecules on which they act. Since the surface area increases with the molecular length for straight-chain alkanes, the dispersion forces also...
Physical Properties of Alcohols and Phenols02:32

Physical Properties of Alcohols and Phenols

Alcohols are organic compounds in which a hydroxy group is attached to a saturated carbon. Phenols are a class of alcohols containing a hydroxy group attached to an aromatic ring. The physical properties of the alcohols and phenols are influenced by hydrogen bonding due to the oxygen–hydrogen dipole in the hydroxy functional group and dispersion forces between alkyl or aryl regions of alcohol and phenol molecules.
Alcohols possess a higher boiling point than aliphatic hydrocarbons of similar...
Physical Properties of Ethers02:17

Physical Properties of Ethers

Overview
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...
Acidity and Basicity of Alcohols and Phenols02:36

Acidity and Basicity of Alcohols and Phenols

Like water, alcohols are weak acids and bases. This is attributed to the polarization of the O–H bond making the hydrogen partially positive. Moreover, the electron pairs on the oxygen atom of alcohol make it both basic and nucleophilic. Protonation of an alcohol converts hydroxide, a poor leaving group, into water—a good one. The two acid–base equilibria corresponding to ethanol are depicted below.
Physical Properties of Amines01:26

Physical Properties of Amines

Amines with low molecular weight are usually gaseous at room temperature, while those with high molecular weight are liquid or solids in nature. Usually, low molecular weight amines have a rotten fish-like smell. Diamines typically have a pungent smell. For instance, cadaverine and putrescine, depicted in Figure 1, are two molecules responsible for decaying tissue.