Related Experiment Video
Updated: Jun 4, 2026

Use of an Integrated Low-Flow Anesthetic Vaporizer, Ventilator, and Physiological Monitoring System for Rodents
Published on: July 9, 2020
Control of the haemodynamic response to surgical stimuli in semi-closed circuit or closed circuit anaesthesia using a
1Department of Anaesthesiology and Pain Medicine, Korea University Anam Hospital, Seoul, Republic of Korea.
Abstract:
This study compared the ability of the Zeus multifunctional anaesthesia system to control haemodynamic response to surgical stimulation in semi-closed (SCA) or closed circuit anaesthesia (CCA) modes. Fifty patients undergoing gynaecological surgery were randomly assigned to SCA or CCA. Anaesthesia was induced with 2 mg propofol and 0.9 mg/kg rocuronium, intravenously, and maintained using sevoflurane (minimum alveolar concentration [MAC], 1.0) using 2 l/min oxygen plus 2 l/min nitrous oxide (SCA 4 l/min group) or 50% oxygen plus 50% nitrous oxide (CCA group). An increase in mean arterial pressure (MAP) > 20% above baseline in response to surgical stimulation provoked a stepwise increase in sevoflurane (1.3 MAC and then 1.6 MAC), followed by fentanyl 1 pg/kg intravenously (rescue drug). The time required for MAP to return to within 10% of baseline was significantly shorter in the CCA group (6.4 +/- 3.6 min) compared with the SCA 4 l/min group (10.2 +/- 6.0 min). The percentage of patients requiring fentanyl was significantly greater in the SCA 4 l/min group than in the CCA group. In conclusion, CCA controlled acute haemodynamic responses to surgical stimuli more successfully and rapidly than SCA 4 l/min, using a multifunctional anaesthesia machine.
Related Concept Videos
General Anesthesia: Overview
General anesthesia induces unconsciousness in the whole body, while the others target specific areas or sensations. It is administered to minimize adverse effects, maintain...
Stages of General Anesthesia
Cardiomyopathy VII: Pre and Post Operative Nursing Management
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal and...
