Cervical spine curvature during simulated rear crashes with energy-absorbing seat

Paul C Ivancic1, Ming Xiao

  • 1Biomechanics Research Laboratory, Department of Orthopaedics and Rehabilitation, Yale University School of Medicine, 333 Cedar St, PO Box 208071, New Haven, CT 06520-8071, USA. paul.ivancic@yale.edu

Abstract

Related Concept Videos

Vertebral Column: Regions and Curvature01:16

Vertebral Column: Regions and Curvature

The vertebral column or spine is a flexible column that supports the head, neck, and body and  allows for their movements. It also protects the spinal cord.
Regions of the Vertebral Column
In an adult, the spine is subdivided into five regions: the cervical, the thoracic, the lumbar, the sacral, and the coccygeal region. The spine initially develops as a series of 33 vertebrae; after 20 years of age, the nine bones in the sacral region, five sacral, and four coccygeal bones fuse to form the...
Bending of Curved Members - Strain Analysis01:14

Bending of Curved Members - Strain Analysis

The mechanics of deformation in curved members, such as beams or arches, under bending moments, involve complex responses. When such a member, symmetric about the y-axis and shaped like a segment of a circle centered at point C, is subjected to equal and opposite forces, its curvature and surface lengths change significantly. This alteration results in the shift of the curvature's center from C to C', indicating a tighter curve.
The important part of bending analysis for such a member is the...
Normal and Tangetial Components: Problem Solving01:24

Normal and Tangetial Components: Problem Solving

Consider a man with a mass of 70 kg seated in a chair connected to a pin support through a member BC. If the man maintains an upright position, the task is to determine the horizontal and vertical reactions of the chair on the man when the member makes a 45° angle with the horizontal. At this moment, the man has a speed of 5 m/s, increasing at a rate of 1 m/s².
Bending of Curved Members - Neutral Surface01:16

Bending of Curved Members - Neutral Surface

In curved beams, unlike straight beams, the stress distribution across the cross-section is not uniform due to the beam's curvature. This non-uniformity arises because the neutral axis, where stress is zero, does not align with the centroid of the section. In a curved beam, the strain varies along the section as a function of the distance from the neutral axis.
Consider the curved member described in the previous lesson. According to Hooke's law, which relates stress to strain within the...
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...