Confounding is a critical issue in epidemiological studies, often leading to misleading conclusions about associations between exposures and outcomes. It occurs when the relationship between the exposure and the outcome is mixed with the effects of other factors that influence the outcome. Given that, addressing confounding is of high importance for drawing accurate inferences in research.
Confounding can be addressed at both the design phase of a study and through analytical methods after data...

Confounding in statistical epidemiology represents a pivotal challenge, referring to the distortion in the perceived relationship between an exposure and an outcome due to the presence of a third variable, known as a confounder. This variable is associated with both the exposure and the outcome but is not a direct link in their causal chain. Its presence can lead to erroneous interpretations of the exposure's effect, either exaggerating or underestimating the true association. This phenomenon...

The randomization process involves assigning study participants randomly to experimental or control groups based on their probability of being equally assigned. Randomization is meant to eliminate selection bias and balance known and unknown confounding factors so that the control group is similar to the treatment group as much as possible. A computer program and a random number generator can be used to assign participants to groups in a way that minimizes bias.
Simple randomization
Simple...

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which child was...

Genome-wide association studies or GWAS are used to identify whether common SNPs are associated with certain diseases. Suppose specific SNPs are more frequently observed in individuals with a particular disease than those without the disease. In that case, those SNPs are said to be associated with the disease. Chi-square analysis is performed to check the probability of the allele likely to be associated with the disease.
GWAS does not require the identification of the target gene involved in...

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...