Related Experiment Video
Updated: Jun 3, 2026
An Anesthesia, Surgery, and Harvest Method for the Evaluation of Transpedicular Screws Using an In Vivo Porcine Lumbar Spine Model
Published on: May 31, 2017
[An anatomic study of posterior C(2) spinous process laminar screw fixation]
Guan-Yi Liu1, Rong-Ming Xu, Wei-Hu Ma
1Department of Orthopaedics, Ningbo Sixth People's Hospital, Ningbo, China.
Objectives:
To explore the feasibility and the technical parameters in posterior C2 spinous process laminar screw fixation, and discuss the clinic significance of C2 spinous process laminar screws.
Methods:
Twenty cervical cadaveric spines of C2 were dissected, with care taken to expose the lamina and spinous process. After the entrance point of spinous process screw were determined, posterior C2 spinous process laminar screw implantation was performed under visual control. On the morphologic CT scan, the angle and length of the spinous process laminar screw trajectory and the distance between the tip of the screw and the spinal cord and the vertebral artery were measured.
Results:
The C2 spinous process laminar screws were successfully placed, without impingement of the spinal cord and the vertebral artery. There were little differences between superior and inferior screws in the angle, trajectory length and the distance between the tip of the screw and the spinal cord and the vertebral artery, but without significance (P > 0.05). The placed angles of the screws were 76.8° ± 10.6° in the axial plane. The distance between the tip of the screw and the spinal cord and the vertebral artery was (5.3 ± 1.6) mm and (17.4 ± 3.7) mm respectively. The trajectory length was (23.1 ± 3.2) mm.
Conclusions:
Posterior C2 spinous process laminar screw fixation is feasible. C2 spinous process laminar screw fixation affords an alternative to standard screw placement for plate fixation and cervical stabilization.
