Evaluation of the Dyre shoving model using dynamic data near the glass temperature

Ben Xu1, Gregory B McKenna

  • 1Department of Chemical Engineering, Texas Tech University, Lubbock, Texas 79409-3121, USA.

Related Concept Videos

Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...
The Kinetic Model of Gases01:24

The Kinetic Model of Gases

The kinetic model of gases explains the properties of a perfect gas using three main assumptions: molecules move in ceaseless random motion, their size is negligible compared to the distances between them, and they do not interact except during perfectly elastic collisions. The total energy of a gas is the sum of the kinetic energies of all its constituent molecules. The pressure exerted by the gas arises from the continual bombardment of the container walls by billions of colliding molecules.
Le Chatelier's Principle: Changing Temperature02:19

Le Chatelier's Principle: Changing Temperature

Consistent with the law of mass action, an equilibrium stressed by a change in concentration will shift to re-establish equilibrium without any change in the value of the equilibrium constant, K. When an equilibrium shifts in response to a temperature change, however, it is re-established with a different relative composition that exhibits a different value for the equilibrium constant.
To understand this phenomenon, consider the elementary reaction:
Temperature and Thermal Equilibrium01:11

Temperature and Thermal Equilibrium

Heat and temperature are essential concepts for everyone every day. The study of heat and temperature is part of an area of physics known as thermodynamics. It is not always easy to distinguish heat and temperature.
The concept of temperature has evolved from the common concepts of hot and cold. The scientific definition of temperature explains more than just our sense of hot and cold. Temperature is operationally defined as the quantity measured with a thermometer. Furthermore, temperature is...
Heat Capacities of an Ideal Gas III01:25

Heat Capacities of an Ideal Gas III

The number of independent ways a gas molecule can move along straight line, rotate, and vibrate is called its degrees of freedom. Supposing d represents the number of degrees of freedom of an ideal gas, the molar heat capacity at constant volume of an ideal gas in terms of d is
Heat Capacities of an Ideal Gas II01:23

Heat Capacities of an Ideal Gas II

For a system that undergoes a thermodynamic process at a constant volume condition, the heat absorbed is used only to increase the system's internal energy and not for doing any kind of work. While for a system undergoing a thermodynamic process under a constant pressure condition, the amount of heat absorbed is used not only for increasing the internal energy (as a function of temperature) but also for doing some work. The molar heat capacity is the amount of heat required to increase the...