Crowe Type I and II DDH managed by large diameter metal-on-metal total hip arthroplasty

Large bearing metal-on-metal (MOM) total hip arthroplasty (THA) may offer advantages relating to stability and range of motion in patients with Crowe Type I and II developmental dysplasia of the hip (DDH). The purpose of this study was to provide an analysis of the clinical and radiological results of MOM THA in this context and compare the results with a cohort of patients treated with metal-on-polyethylene (MOP) bearing surfaces. 75 hips in 65 patients were treated with cementless MOM THA using large femoral heads (36-56 mm). The mean age of the patients was 47.4 years (29 to 59) and 54 were female. A group of 47 hips (41 patients) treated with conventional THA (screwed cup-polyethylene insert-28 mm head) was used for comparison. The study group was followed up for a mean of 62.1 months (32 to 76). No difference was found between the two groups in relation to improvement in Harris hip score (HHS) (43.1 to 90.3 points in the study group, 42.6 to 89.5 points in the control group, p>0.05). Although the preoperative range of motion in all planes were similar in both groups, the large head group demonstrated greater motion in all planes postoperatively, which was significant (all p=0.001). Additionally, there was a significant difference between groups in relation to the necessity for acetabular structural graft (8% and 31.9%, respectively; p=0.001). No major complications or adverse reactions to metal debris (ARMD) were observed in the study group. The results of large head MOM THA in young and active patients with DDH are similar to conventional THA at early follow-up, but the former offers the advantages of secure acetabular fixation without screws, greater range of motion, and lower risk of dislocation.