Related Experiment Video

Updated: Jun 2, 2026

Synthesis of Information-bearing Peptoids and their Sequence-directed Dynamic Covalent Self-assembly
09:34

Synthesis of Information-bearing Peptoids and their Sequence-directed Dynamic Covalent Self-assembly

Published on: February 6, 2020

Conformational polymorphism of (E,E)-N,N'-bis(4-nitrobenzylidene)benzene-1,4-diamine

Alain Collas1, Matthias Zeller, Frank Blockhuys

  • 1Department of Chemistry, University of Antwerp, Universiteitsplein 1, B-2610 Antwerp, Belgium.

Acta Crystallographica. Section C, Crystal Structure Communications
|May 5, 2011
PubMed

More Related Videos

Facile Preparation of (2Z,4E)-Dienamides by the Olefination of Electron-deficient Alkenes with Allyl Acetate06:46

Facile Preparation of (2Z,4E)-Dienamides by the Olefination of Electron-deficient Alkenes with Allyl Acetate

Published on: June 21, 2017

Construction and Systematical Symmetric Studies of a Series of Supramolecular Clusters with Binary or Ternary Ammonium Triphenylacetates06:35

Construction and Systematical Symmetric Studies of a Series of Supramolecular Clusters with Binary or Ternary Ammonium Triphenylacetates

Published on: February 15, 2016

Related Concept Videos

Structure of Conjugated Dienes01:16

Structure of Conjugated Dienes

Introduction
Conjugated dienes are compounds characterized by the presence of alternating double and single bonds. In a conjugated system like 1,3-butadiene, the unhybridized 2p orbital on each carbon overlaps continuously, allowing the π electrons to be delocalized across the entire molecule. In contrast, this type of overlap does not occur in cumulated and isolated dienes, such as 2,3-pentadiene and 1,4-pentadiene, respectively. Instead, the π electrons remain localized between the double...
Isomerism in Alkenes02:01

Isomerism in Alkenes

Alkenes like 1-butene and 2-butene exhibit constitutional isomerism, as they differ in the position of the double bond. Further, 2-butene exhibits stereoisomerism and exists as two distinct compounds differing in spatial arrangement.
An isomer is called cis-2-butene when the methyl groups are on the same side of the double bond, and the other stereoisomer, in which methyl groups are on the opposite side of the double bond, is called trans-2-butene. The cis and trans stereoisomers are not...
Structure of Amines01:19

Structure of Amines

The hybridized nitrogen atom in amines possesses a lone pair of electrons and is bound to three substituents with a bond angle of around 108°, which is less than the tetrahedral angle of 109.5°. However, the C–N–H bond angle is slightly larger at 112°, with a carbon–nitrogen bond length of 147 pm. This carbon–nitrogen bond length of of amines is longer than the carbon–oxygen bond of alcohols (143 pm) but shorter than alkanes’ carbon–carbon bond (154 pm). These aspects are illustrated in Figure...
Nomenclature of Primary Amines01:17

Nomenclature of Primary Amines

Primary, secondary, and tertiary amines are compounds consisting of one, two, and three alkyl groups connected to the amino group (–NH2), respectively. As depicted in Figure 1, the common name of the primary amines is obtained by adding the suffix -amine to the alkyl substituent attached to the amino group as the corresponding alkylamine.
Conformations of Ethane and Propane02:18

Conformations of Ethane and Propane

In an organic molecule, free rotation about the carbon-carbon single bond results in energetically different conformers of the molecule. Due to this rotation, called the internal rotation, ethane has two major conformations — staggered and eclipsed.
Staggered conformation is a low energy and more stable conformation with the C-H bonds on the front carbon placed at 60°dihedral angles relative to the C-H bonds on the back carbon, leading to a reduced torsional strain. In staggered ethane, the...
Conformations of Cyclohexane02:11

Conformations of Cyclohexane

Cyclohexane does not exist in a planar form due to the high angle and torsional strain it would experience in the planar structure. Instead, it adopts non-planar chair and boat conformations.
The chair form is the most stable and derives its name from its resemblance to the “easy chair.” In the chair conformation, two carbon atoms are arranged out-of-plane — one above and one below, minimizing the torsional strain. In the chair form, the bond angle is very close to the ideal tetrahedral value,...