Preparation and characterization of microparticles of piroxicam by spray drying and spray chilling methods

Piroxicam, an anti-inflammatory drug, exhibits poor water solubility and flow properties, poor dissolution and poor wetting. Consequently, the aim of this study was to improve the dissolution of piroxicam. Microparticles containing piroxicam were produced by spray drying, using isopropyl alcohol and water in the ratio of 40:60 v/v as solvent system, and spray chilling technology by melting the drug and chilling it with a pneumatic nozzle to enhance dissolution rate. The prepared formulations were evaluated for in vitro dissolution and solubility. The prepared drug particles were characterized by scanning electron microscopy (SEM), differential scanning calorimeter, X-ray diffraction and Fourier transform infrared spectroscopy. Dissolution profile of the spray dried microparticles was compared with spray-chilled microparticles, pure and recrystallized samples. Spray dried microparticles and spray chilled microparticles exhibited decreased crystallinity and improved micromeritic properties. The dissolution of the spray dried microparticle and spray chilled particles were improved compared with recrystallized and pure sample of piroxicam. Consequently, it was believed that spray drying of piroxicam is a useful tool to improve dissolution but not in case of spray chilling. This may be due to the degradation of drug or variations in the resonance structure or could be due to minor distortion of bond angles. Hence, this spray drying technique can be used for formulation of tablets of piroxicam by direct compression with directly compressible tablet excipients.