Related Experiment Video
Updated: Jun 1, 2026

Waste Water Derived Electroactive Microbial Biofilms: Growth, Maintenance, and Basic Characterization
Published on: December 29, 2013
Examination of microbial fuel cell start-up times with domestic wastewater and additional amendments
Guangli Liu1, Matthew D Yates, Shaoan Cheng
1School of Environmental Science & Engineering, Sun Yat-sen University, Guangzhou, PR China.
Abstract:
Rapid startup of microbial fuel cells (MFCs) and other bioreactors is desirable when treating wastewaters. The startup time with unamended wastewater (118 h) was similar to that obtained by adding acetate or fumarate (110-115 h), and less than that with glucose (181 h) or Fe(III) (353 h). Initial current production took longer when phosphate buffer was added, with startup times increasing with concentration from 149 h (25 mM) to 251 h (50 mM) and 526 h (100 mM). Microbial communities that developed in the reactors contained Betaproteobacteria, Acetoanaerobium noterae, and Chlorobium sp. Anode biomass densities ranged from 200 to 600 μg/cm(2) for all amendments except Fe(Ш) (1650 μg/cm(2)). Wastewater produced 91 mW/m(2), with the other MFCs producing 50 mW/m(2) (fumarate) to 103mW/m(2) (Fe(III)) when amendments were removed. These experiments show that wastewater alone is sufficient to acclimate the reactor without the need for additional chemical amendments.
More Related Videos
Related Concept Videos
Microbial Fuel Cells
Microbial Wastewater Treatment
Biological Treatment of Effluent and Waste Water
Environmental Applications of Microorganisms
Biofuels

