Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Clamper Circuit01:14

Clamper Circuit

A clamper circuit, also known as a DC restorer, represents a specialized variant of the rectifier circuit, notable for its method of taking the output across the diode rather than the capacitor. This configuration lends to several distinctive applications, particularly in handling square wave inputs.
Within this circuit, the diode's orientation prompts the capacitor to charge up to the level of the most negative peak of the input signal. Upon reaching this state, the diode ceases to conduct,...
Applications of RC Circuits01:22

Applications of RC Circuits

A relaxation oscillator is one of the applications of RC circuits. A neon lamp relaxation oscillator comprises a capacitor, a resistor, a voltage source, and a lamp. The lamp acts like an open circuit, with infinite resistance until the potential difference across the lamp reaches a specific voltage. At that voltage, the lamp acts like a short circuit with zero resistance, and the capacitor discharges through the lamp, thus producing light. Once the capacitor is fully discharged through the...
Special considerations while measuring pulse01:13

Special considerations while measuring pulse

Assessing a patient's pulse is a fundamental skill in healthcare, but certain situations require special attention:
Design Example: Capacitance Multiplier Circuit01:20

Design Example: Capacitance Multiplier Circuit

In integrated circuit technology, a capacitance multiplier is often utilized to produce a larger capacitance value when a small physical capacitance falls short. This is achieved by a circuit that multiplies capacitance values by a factor of up to 1000, such that a 10-pF capacitor can replicate the performance of a 100-nF capacitor.
The circuit illustrated in Figure 1 below incorporates two op-amps, with the first operating as a voltage follower and the second acting as an inverting amplifier.
Clipper Circuit01:18

Clipper Circuit

A clipper circuit is a fundamental wave-shaping device that harnesses the unique properties of diodes to alter and control waveform characteristics. This technology is widely used in electronic devices, especially in television and radar communication systems, where it enhances waveform modulation in both transmitters and receivers.
The operation of a clipper circuit can be exemplified by analyzing a dual-clipper configuration setup that integrates two ideal diodes, each paired with a biasing...
Electronic Distance Measuring Instruments01:30

Electronic Distance Measuring Instruments

Electronic Distance Measuring Instruments (EDMs) are essential tools in modern surveying, offering precise distance measurements by emitting electromagnetic signals and calculating the time required for these signals to travel to a target and return. Two primary types of signals are used in EDMs — light waves and microwaves — each suited to specific environmental and distance requirements. Light-wave-based EDMs utilize either infrared or laser light, providing high accuracy over short distances...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Development of a nucleotide prodrug of 4'-fluorouridine to improve tolerability.

European journal of medicinal chemistry·2026
Same author

What Is the Information Content of EPR Oximetry?

Advances in experimental medicine and biology·2026
Same author

Electron paramagnetic resonance detection of superoxide in a murine model of acute lung injury.

Discover imaging·2025
Same author

Have We Been Teaching Continuous Wave EPR Correctly?

Journal of chemical education·2025
Same author

Compact 1 GHz electron paramagnetic resonance spectrometer and imager.

The Review of scientific instruments·2025
Same author

Comparison of 10 mm and 30 mm Diameter Surface Coil Resonators for 1 GHz EPR.

Applied magnetic resonance·2025
Same journal

Odd-Leg Birdcages for Geometric Decoupling in Multinuclear Imaging and Spectroscopy.

Concepts in magnetic resonance. Part B, Magnetic resonance engineering·2025
Same journal

Quasistatic Solutions versus Full-Wave Solutions of Single-Channel Circular RF Receive Coils on Phantoms of Varying Conductivities at 3 Tesla.

Concepts in magnetic resonance. Part B, Magnetic resonance engineering·2021
Same journal

Capacitive versus Overlap Decoupling of Adjacent Radio Frequency Phased Array Coil Elements: An Imaging Robustness Comparison When Sample Load Varies for 3 Tesla MRI.

Concepts in magnetic resonance. Part B, Magnetic resonance engineering·2021
Same journal

The "Loopole" Antenna: A Hybrid Coil Combining Loop and Electric Dipole Properties for Ultra-High-Field MRI.

Concepts in magnetic resonance. Part B, Magnetic resonance engineering·2021
Same journal

Single-point Dixon water-fat imaging using 64-channel single-echo acquisition MRI.

Concepts in magnetic resonance. Part B, Magnetic resonance engineering·2019
Same journal

Traveling-wave meets standing-wave: A simulation study using pair-of-transverse-dipole-ring (PTDR) coils for adjustable longitudinal coverage in ultra-high field MRI.

Concepts in magnetic resonance. Part B, Magnetic resonance engineering·2019
See all related articles

Related Experiment Video

Updated: Jun 1, 2026

Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source
12:19

Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source

Published on: April 4, 2017

A General Purpose Q-Measuring Circuit Using Pulse Ring-Down.

Richard W Quine1, Deborah G Mitchell, Gareth R Eaton

  • 1School of Engineering and Computer Science, University of Denver, Denver, CO 80208.

Concepts in Magnetic Resonance. Part B, Magnetic Resonance Engineering
|May 25, 2011
PubMed
Summary
This summary is machine-generated.

A new pulsed microwave circuit enables resonator Q measurement using the pulse ring-down method in Electron Paramagnetic Resonance (EPR) spectrometers lacking pulse capabilities. This adaptable circuit was successfully tested in an X-band EPR bridge.

More Related Videos

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators
09:46

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators

Published on: August 8, 2025

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping
14:58

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping

Published on: June 3, 2015

Related Experiment Videos

Last Updated: Jun 1, 2026

Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source
12:19

Measurement of Quantum Interference in a Silicon Ring Resonator Photon Source

Published on: April 4, 2017

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators
09:46

Fabrication and Characterization of High-Q Silicon Nitride Membrane Resonators

Published on: August 8, 2025

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping
14:58

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping

Published on: June 3, 2015

Area of Science:

  • Physics
  • Spectroscopy
  • Electronics Engineering

Background:

  • Electron Paramagnetic Resonance (EPR) spectroscopy is a powerful technique for studying materials with unpaired electrons.
  • Measuring the quality factor (Q) of resonators is crucial for optimizing EPR spectrometer performance.
  • Conventional EPR spectrometers often lack the necessary pulse capabilities for certain advanced measurement techniques.

Purpose of the Study:

  • To develop a general-purpose pulsed microwave circuit for measuring resonator Q.
  • To enable the use of the pulse ring-down method in EPR spectrometers without inherent pulse capability.
  • To adapt this technology for various microwave frequencies and spectrometer types.

Main Methods:

  • Development of a custom-designed pulsed microwave circuit.
  • Integration and testing of the circuit within a standard Bruker X-band EPR bridge.
  • Application of the pulse ring-down method for resonator Q determination.

Main Results:

  • Successful implementation of a pulsed microwave circuit for resonator Q measurement.
  • Demonstration of the pulse ring-down method's viability in a non-pulsed EPR setup.
  • Validation of the circuit's functionality within an X-band EPR spectrometer.

Conclusions:

  • The developed pulsed microwave circuit effectively facilitates resonator Q measurements via the pulse ring-down method.
  • This technology broadens the applicability of advanced EPR measurement techniques to a wider range of spectrometers.
  • The circuit's design offers potential for adaptation across different microwave frequencies and EPR systems.