Related Experiment Video
Updated: Jun 1, 2026

A Two-interval Forced-choice Task for Multisensory Comparisons
Published on: November 9, 2018
A comparison of reliability measures for continuous and discontinuous recording methods: inflated agreement scores
John T Rapp1, Regina A Carroll, Lindsay Stangeland
1St. Cloud State University, St. Cloud, MN 56301-4495, USA. jtrapp@stcloudstate.edu
Abstract:
The authors evaluated the extent to which interobserver agreement (IOA) scores, using the block-by-block method for events scored with continuous duration recording (CDR), were higher when the data from the same sessions were converted to discontinuous methods. Sessions with IOA scores of 89% or less with CDR were rescored using 10-s partial interval recording (PIR) and 10-s momentary time sampling (MTS). Results indicated that IOA scores for 10-s PIR and 10-s MTS were consistently higher than IOA scores based on CDR for the same sessions. Specifically, 10-s MTS provided higher overestimations for low-duration events, whereas 10-s PIR produced higher overestimations for moderate- and high-duration events. Implications for researchers and clinicians are briefly discussed.
Related Concept Videos
Interval Level of Measurement
Data measured using the interval scale are similar to ordinal level data because they have a definite arrangement. However, in the interval level of measurement, the differences between data values are meaningful even though the data does not have a starting point.
Temperature is measured using the interval scale. It is measurable data, and the difference between the...
Sampling Continuous Time Signal
In the...
Statistical Analysis: Overview
One of the most commonly used statistical quantifiers is the mean, which is the ratio between the sum of the numerical values of all results and the...
Ratio Level of Measurement
A set of data measured using the ratio scale takes care of the ratio problem and provides complete information. Ratio scale data are like interval scale data, except they have a zero point and ratios can be calculated. For...
Reliability and Validity
Uncertainty in Measurement: Accuracy and Precision
