Related Experiment Video
Updated: Jun 1, 2026
Amplifying and Quantifying HIV-1 RNA in HIV Infected Individuals with Viral Loads Below the Limit of Detection by Standard Clinical Assays
Published on: September 26, 2011
Development of candidate reference reagent for HIV-1 RNA and comparison analysis for different HIV-1 RNA quantitative
Borae G Park1, Ae Ja Park, Jee-Hye Choi
1Department of Laboratory Medicine, University of Ulsan College of Medicine and Asan Medical Center, Seoul, Republic of Korea.
Background:
Human immunodeficiency virus type-1 (HIV-1) RNA viral load is a surrogate marker that is routinely used to determine indications for, and monitor the effectiveness of HIV-1 treatment. We developed three reagents for potential use in routine quality control of HIV-1 RNA quantitative assays. In this report, we compare the stability of these re-agents in storage and compare their performance in three different HIV-1 RNA quantitative assays.
Methods:
The candidate reagents were derived from readily available pre-existing reagents and examined for stability at different storage temperatures. They were compared in three commercially available HIV-1 RNA quantitative assays: the Cobas TaqMan HIV-1 Test (Cobas TaqMan), the RealTime HIV-1 Assay (Abbott RealTime), and the NucliSens EasyQ HIV-1 Assay v1.1 (NucliSens EasyQ).
Results:
The candidate reagent derived from an HIV culture supernatant (candidate CS) was the most stable of the three candidates and showed good reproducibility. Candidate CS yielded the highest HIV-1 titer of the three candidates in the Cobas TaqMan assay and the lowest HIV-1 titer and stability of the three candidates in the NucliSens EasyQ system.
Conclusions:
The candidate CS is the most appropriate of the three candidate reagents for quantitative testing of HIV-1 RNA. This working reagent should be useful for use in routine calibration for quality control in centers with limited financial resources. The Cobas TaqMan assay tended to yield higher viral load results than the other assays when used with our three candidate reagents.
