Formulation and stability testing of itraconazole crystalline nanoparticles

Itraconazole (ITZ) crystalline nanoparticles were prepared using relatively simple, low-cost sonoprecipitation technique, in which both the solvent and antisolvent were organic in nature. The effect of stabilizer type (hydroxypropyl methylcellulose, hydroxypropyl cellulose, Inutec SP1®, and pluronic F127), drying method (oven and freeze drying) and matrix former used (Avicel PH101, and Aerosil®200) on the dissolution performance as a key characteristic of nanocrystals was evaluated. In 10 min, all of the prepared nanocrystals showed 3.77-8.59 times improvement in percent drug dissolved compared to pure ITZ. Concerning the effect of stabilizer type, the following rank order can be given: pluronic F127 ≥ hydroxypropyl cellulose ≥ hydroxypropyl methylcellulose (HPMC) > inutec SP1. Freeze-dried ITZ nanocrystals containing Avicel PH 101 showed better dissolution rate compared to other nanocrystals. The chemical structure of itraconazole nanocrystals was not changed as revealed by Fourier transform infrared. Stability study of selected nanocrystals (F5, F7, and F8) revealed physical and chemical stability of F7 and F8, while a decrease in dissolution rate of F5 was observed (although being chemically stable) when stored under high relative humidity conditions. Although inutec is less potent than pluronic F127 and HPMC regarding their effect on dissolution rate enhancement, it is equipotent to pluronic F127 in preserving the rapid drug dissolution.