Characterization and inventory of PCDD/Fs and PBDD/Fs emissions from the incineration of waste printed circuit board

Many developing countries have not significantly changed their course with regard to electronic waste contamination, and they are still facing the specter of mountains of hazardous electronic waste, with serious consequences for both the environment and public health. An efficient and stable analytical method was developed to determine the inventory and emission factors of polybrominated dibenzo-p-dioxin and dibenzofurans (PBDD/Fs) and polychlorinated dibenzo-p-dioxin and dibenzofurans (PCDD/Fs) formed from the incineration of scrap printed circuit boards (PCBs). Both PBDD/Fs and PCDD/Fs have been found in all experimental sections with a maximum formation rate at temperatures between 250 and 400 °C. The amounts tended first to increase and then began to decrease as the temperature rose. When subjected to a heating temperature of 325 °C, the total content of twelve 2,3,7,8-substituted PBDD/Fs congeners (tetra- through octabromo-) gathered from three outputs was the largest, at 19 000, 160 000, and 57 ng TEQ/kg in solid, liquid, and gaseous fractions, respectively; the total content of seventeen 2,3,7,8-substituted PCDD/Fs congeners (tetra- through octachloro-) was 820, 550, and 1.4 ng TEQ/kg. The formation of PCDD/Fs was remarkably less than that of PBDD/Fs because bromine concentrations considerably exceeded chlorine concentrations. The ingredients and conditions necessary to form PCDD/Fs or PBDD/Fs were definitely present, such as products of incomplete combustion, halogenides, an oxidizing atmosphere, and a catalyst-Cu salts being the most effective, significantly increasing the yields of PCDD/Fs and PBDD/Fs and decreasing the optimum temperature range.