Related Experiment Video
Updated: May 31, 2026

Preparation of Biomass-based Mesoporous Carbon with Higher Nitrogen-/Oxygen-chelating Adsorption for Cu(II) Through Microwave Pre-Pyrolysis
Published on: February 12, 2019
Adsorption of copper(II) onto sewage sludge-derived materials via microwave irradiation
1State Key Laboratory of Pollution Control and Resources Reuse, College of Environmental Science and Engineering, Tongji University, Shanghai 200092, China. wangxj@tongji.edu.cn
Abstract:
The materials with adsorbent properties were produced from urban sewage sludge by two different procedures via microwave irradiation: (1) by one single pyrolysis stage (SC); (2) by chemical activation with ZnCl(2) (SZ). The BET, SEM and FT-IR have been used to evaluate the pore structural parameters and surface chemistry of the adsorbents, respectively. Subsequently they were used for adsorption of Cu(II) from aqueous solutions. The effects of various experimental parameters, such as pH, temperature were investigated in a batch-adsorption technique. The results showed that the adsorption of Cu(II) was maximal at pH 5.0. The kinetic study demonstrated that the adsorption process was followed the second-order kinetic equation. The experimental adsorption isotherm data were well fitted with Langmuir model and the maximum adsorption capacity of Cu(II) were found to be 3.88 and 10.56 mg/g for SC and SZ, respectively, in the solution of pH 5.0. Thermodynamic parameters such as changes in the enthalpy (ΔH(0)), entropy (ΔS(0)) and free energy (ΔG(0)) indicate that Cu(II) adsorption onto SC and SZ is an endothermic and spontaneous process in nature at 15-45°C. These results indicate that the sewage sludge-derived material via microwave induced ZnCl(2) activation is an effective and alternative adsorbent for the removal of Cu(II) from aqueous solution.
More Related Videos
06:36Preparation of Expanded Chitin Foams and their Use in the Removal of Aqueous Copper
Published on: February 27, 2021
10:31Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
Published on: December 6, 2015
Related Concept Videos
Microbial Leaching
Microbial Bioremediation of Uranium
Biological Treatment of Effluent and Waste Water
Acid Mine Drainage
Microbial Corrosion
Precipitation and Co-precipitation