Related Experiment Video
Updated: May 30, 2026
07:55
Flexural Rigidity Measurements of Biopolymers Using Gliding Assays
Published on: November 9, 2012
Anomalous dispersion of flexural guided waves in clad rods
Abstract:
In clad rods, the dispersion properties of firstorder flexural [F(1, 1)] modes can differ from other modes. Normal and Stoneley modes and the existence criteria for four F(1, 1) modes are investigated. We focus on low-frequency anomalous dispersion, which occurs only in F(1, 1) modes and is sensitive to shear velocity.
Related Concept Videos
01:16Flexural Stress
When analyzing bending in symmetric members, it's crucial to understand how stresses distribute when subjected to bending moments. This stress distribution is effectively described by applying fundamental mechanics and material science principles, particularly Hooke's Law for elastic materials.
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
Hooke's Law states that within the material's elastic limits, stress is directly proportional to strain. In a member experiencing a bending moment, the strain at any point is relative to its distance...
01:12Temperature Dependent Deformation
In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...
01:16Eccentric Axial Loading in a Plane of Symmetry
Eccentric axial loading occurs when an axial load is applied away from the centroidal axis of a structural member. This scenario is common in engineering, where structural elements may not be directly aligned due to various design or functional requirements.
01:23Unsymmetric Loading of Thin-Walled Members
Thin-walled members with non-symmetrical cross-sections are vital to engineering structures, offering material efficiency and structural integrity. However, unsymmetrical loading on these members leads to complex stress distributions, resulting in simultaneous bending and twisting can cause deformation or structural failure. The interaction between bending and twisting requires detailed analysis to ensure structural resilience.
The concept of the shear center is crucial in countering the...
The concept of the shear center is crucial in countering the...
01:11Distribution of Stresses in a Narrow Rectangular Beam
In studying beam stress distribution, examining an elemental section is essential. To determine the average shearing stress on this face, the calculated shear is divided by the surface area. Importantly, shearing stresses on the beam's transverse and horizontal planes mirror each other, indicating a consistent stress distribution along the upper region of the beam. Notably, shearing stresses are absent at the beam's upper and lower surfaces due to the absence of applied forces in these areas.
01:15Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.