Topographic maps represent the Earth's surface features using contour lines, which connect points of equal elevation to create a two-dimensional representation of three-dimensional terrain. Creating a topographic map requires a systematic approach.Begin by plotting a scaled grid and marking intersections corresponding to the survey's elevation data points. Assign elevation values at these intersections to build the base map. Next, determine contour levels using a consistent contour interval,...

As the name suggests, a multiple bar graph is the same as a bar graph but has multiple bars to depict relationships between different data values. One can include as many parameters as possible. However, each parameter must have the same unit of measurement.
Each bar or column in the multiple bar graph represents a data value. These graphs are used primarily in interrelating two or more sets of data. The categories of different kinds of data are listed along the horizontal or x-axis, whereas...

A residual plot is a statistical representation of data used to analyze correlation and regression results. It helps verify the requirements for drawing specific conclusions about correlation and regression. To obtain the residual plot, first, the residual for each data value is calculated, which is simply the vertical distance between the observed and the predicted value obtained from the regression equation.
When the residual values are plotted against the variable x, it is called a residual...

A time-series graph is a line graph with repeated measurements taken at successive intervals of time. It is also called a time series chart. To construct a time-series graph, one must look at both pieces of a paired data set. The horizontal axis is used to plot the time increments, and the vertical axis is used to plot the values of the variable that one is measuring. By using the axes in this way, each point on the graph will correspond to time and a measured quantity. The points on the graph...

The most common and easiest way to display the relationship between two variables, x and y, is a scatter plot. A scatter plot shows the direction of a relationship between the variables. A clear direction happens when there is either:

An ogive graph is sometimes called a cumulative frequency polygon. It is one type of frequency polygon that shows cumulative frequency. In other words, the cumulative percentages are added to the graph from left to right. An ogive graph plots cumulative frequency on the vertical y-axis and class boundaries along the horizontal x-axis. It’s very similar to a histogram; only instead of rectangles, an ogive displays a single point where the top right of the rectangle would be. Creating this type...