Related Experiment Video

Updated: May 30, 2026

Customization of Aspergillus niger Morphology Through Addition of Talc Micro Particles
10:51

Customization of Aspergillus niger Morphology Through Addition of Talc Micro Particles

Published on: March 15, 2012

Involvement of Physical Parameters in Medium Improvement for Tannase Production by Aspergillus niger FETL FT3 in

I Darah1, G Sumathi, K Jain

  • 1School of Biological Sciences, Universiti Sains Malaysia, 11800 Minden, Penang, Malaysia.

Biotechnology Research International
|August 10, 2011
PubMed

More Related Videos

Design of Solid-State Fermentation Systems for Polymer Hydrolytic Extracellular Enzyme Production by Filamentous Fungi06:08

Design of Solid-State Fermentation Systems for Polymer Hydrolytic Extracellular Enzyme Production by Filamentous Fungi

Published on: June 6, 2025

Related Concept Videos

Bioreactor Controls-II01:18

Bioreactor Controls-II

In aerobic fermentations, oxygen is vital for microbial growth and metabolite production. Since air comprises only about 20% oxygen and the gas is poorly soluble in water—just 9 ppm at 20°C—supplying sufficient oxygen becomes a critical challenge, especially in high-demand processes like yeast growth or citric acid production. Even a fully saturated broth may offer only a few seconds of oxygen availability.To address this, sterile or scrubbed air is introduced into the fermentor via a sparger...
Bioreactor Design and Operational System01:29

Bioreactor Design and Operational System

Bioreactors are engineered vessels designed to cultivate microorganisms under controlled conditions for industrial bioprocessing. They maintain sterility and allow precise regulation of pH, temperature, oxygen, and nutrient levels to optimize microbial growth and metabolite production. Bioreactors range from small laboratory units of 1 liter to industrial systems holding up to 500,000 liters, though only about 75% of their volume is actively used for fermentation. The remaining headspace...
Bioreactor Controls-III01:22

Bioreactor Controls-III

Strain improvement is a foundational strategy in industrial microbiology aimed at maximizing microbial productivity, particularly because natural isolates typically yield commercially valuable products in very low concentrations. Although optimizing the culture medium and environmental conditions can improve yields, these adjustments are inherently limited by the organism’s genetic potential. As a result, the focus shifts toward genetic modifications to enhance biosynthetic capacity. The...
Production of Organic Acids01:25

Production of Organic Acids

Lactic acid, an important organic acid extensively applied in food, pharmaceutical, and biodegradable polymer industries, is primarily produced via microbial fermentation. This method is favored over chemical synthesis due to its environmental sustainability and capacity for enantiomerically pure product formation. Among various microbial processes, the fermentation of starch-based substrates stands out due to the abundance and renewability of raw materials like corn and potatoes.Hydrolysis of...
Production of Alcohol01:27

Production of Alcohol

Continuous fermentation is a key strategy in industrial ethanol production, particularly when efficiency, scalability, and high yields are essential. This approach allows for uninterrupted operation and optimized resource utilization. The primary feedstock, corn starch, undergoes enzymatic hydrolysis facilitated by α-amylase and glucoamylase. These enzymes break down the starch into fermentable sugars such as glucose, which are readily assimilated by fermentative microorganisms.Fermentation...
Scale-Up Processes01:14

Scale-Up Processes

The scale-up of microbial fermentation processes is essential in industrial biotechnology, allowing the transition from laboratory-scale experiments to commercial-scale production while aiming to maintain product yield and quality. This process requires meticulous adjustment of equipment design, process parameters, and contamination control strategies to accommodate increasing culture volumes.At the laboratory scale, cultures are typically maintained in 1 to 10-liter glass or autoclavable...