Related Experiment Video
Updated: May 29, 2026

Synthetic, Multi-Layer, Self-Oscillating Vocal Fold Model Fabrication
Published on: December 2, 2011
Assessment of local vocal fold deformation characteristics in an in vitro static tensile test
M Dollinger1, D A Berry, B Huttner
1Department of Phoniatrics and Pediatric Audiology, University Hospital Erlangen, Germany. michael.doellinger@uk-erlangen.de
Abstract:
Voice quality is strongly dependent on vocal fold dynamics, which in turn are dependent on lung pressure and vocal fold biomechanics. Numerical and physical models are often used to investigate the interactions of these different subsystems. However, the utility of numerical and physical models is limited unless appropriately validated with data from physiological models. Hence a method that enables analysis of local vocal fold deformations along the entire surface is presented. In static tensile tests, forces are applied to distinctive working points being located in cover and muscle, respectively, so that specific layer properties can be investigated. The forces are directed vertically upward and are applied along or above the vocal fold edge. The resulting deformations are analyzed using multiple perspectives and three-dimensional reconstruction. Deformation characteristics of four human vocal folds were investigated. Preliminary results showed two phases of deformation: a range with a small slope for small deformations fading into a significant nonlinear deformation trend with a high slope. An increase of tissue stiffness from posterior to anterior was detected. This trend is more significant for muscle and in the mid-anterior half of the vocal fold.
Related Concept Videos
Yield Criteria for Ductile Materials under Plane Stress
The Maximum Shearing Stress Criterion, also known as the...
Mechanical Characteristics of Steel
The tension test is fundamental for determining tensile strength. In this test, a steel specimen is stretched using a gripping device until it breaks. The data collected during this test are used to...

