Related Experiment Video
Updated: May 29, 2026

An Automated System for Sound Localization Testing in Hearing-Impaired Listeners
Published on: March 13, 2026
Gain-induced speech distortions and the absence of intelligibility benefit with existing noise-reduction algorithms
1Department of Electrical Engineering, University of Texas at Dallas, Richardson, Texas 75080, USA.
Abstract:
Most noise-reduction algorithms used in hearing aids apply a gain to the noisy envelopes to reduce noise interference. The present study assesses the impact of two types of speech distortion introduced by noise-suppressive gain functions: amplification distortion occurring when the amplitude of the target signal is over-estimated, and attenuation distortion occurring when the target amplitude is under-estimated. Sentences corrupted by steady noise and competing talker were processed through a noise-reduction algorithm and synthesized to contain either amplification distortion, attenuation distortion or both. The attenuation distortion was found to have a minimal effect on speech intelligibility. In fact, substantial improvements (>80 percentage points) in intelligibility, relative to noise-corrupted speech, were obtained when the processed sentences contained only attenuation distortion. When the amplification distortion was limited to be smaller than 6 dB, performance was nearly unaffected in the steady-noise conditions, but was severely degraded in the competing-talker conditions. Overall, the present data suggest that one reason that existing algorithms do not improve speech intelligibility is because they allow amplification distortions in excess of 6 dB. These distortions are shown in this study to be always associated with masker-dominated envelopes and should thus be eliminated.
Related Concept Videos
Effects of feedback
Feedback significantly modifies the gain of a control system. The gain of a system without feedback is altered by a factor of one plus GH, where G represents...
Sound Waves: Interference
Aliasing
If the sampling frequency is below the Nyquist rate, these replicas overlap, preventing the original signal...
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Difference from Background: Limit of Detection
The LOD indicates the presence or absence...
