Related Experiment Video
Updated: May 29, 2026

Non-contact, Label-free Monitoring of Cells and Extracellular Matrix using Raman Spectroscopy
Published on: May 29, 2012
Structural evaluation of myofibrillar proteins during processing of Cantonese sausage by Raman spectroscopy
Weizheng Sun1, Qiangzhong Zhao, Mouming Zhao
1College of Light Industry and Food Sciences, South China University of Technology, Guangzhou 510640, China.
Abstract:
Structural changes of myofibrillar proteins from raw pork muscle and Cantonese sausage at different processing periods were elucidated using Raman spectroscopy. Fourier deconvolution combined with iterative curve fitting were used to analyze the amide I Raman band. Results from amide I, amide III, and C-C stretching vibrations in 890-1060 cm(-1) showed that α-helix decreased accompanied by an increase in β-sheet structure during the first 18 h, and a rebuilding process of secondary structures was observed at the rest stage due to proteolysis. The hierarchical cluster analysis results of amide I and amide III confirmed this rebuilding process. Changes in a doublet near 850 and 830 cm(-1) suggested that some tyrosine residues became buried in a more hydrophobic environment due to intermolecular interactions. Raman spectra in the 2855-2940 cm(-1) region suggested that the environment of aliphatic side chains might have been changed during the final stage and further confirmed above rebuilding process.
More Related Videos
07:46Exploring the Longissimus Muscle: Unraveling its Correlation with Meat Quality in Bos indicus and Crossbred Bulls
Published on: July 12, 2024
09:26Species Determination and Quantitation in Mixtures Using MRM Mass Spectrometry of Peptides Applied to Meat Authentication
Published on: September 20, 2016
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...