Patients presenting with miliaria while wearing flame resistant clothing in high ambient temperatures: a case series

Robert Carter1, Anisa M Garcia, Brian E Souhan

  • 1Thermal and Mountain Medicine Division, US Army Research Institute of Environmental Medicine (USARIEM), Natick, MA, USA. drrobertcarter@gmail.com.

Abstract

Related Concept Videos

Decreased Body Temperature01:29

Decreased Body Temperature

A decreased body temperature can occur in patients with hypothermia and frostbite. Heat loss with extended cold exposure overpowers the body's ability to create heat, resulting in hypothermia. Core temperature readings help classify hypothermia. Mild hypothermia is temperatures between 32 °C (89.6 °F) and 35°C (95 °F) and is caused by impaired thermoregulation. Moderate hypothermia is temperatures between 28 C (82.4 °F) and 32 °C (89.6 °F) caused by sustained extreme cold exposure, and severe...
Increased Body Temperature01:25

Increased Body Temperature

A body temperature above  38°C  (100.4 °F) is known as fever or pyrexia, and a person with fever is termed 'febrile.' Typically, the hypothalamus, a part of the brain that acts as the body's thermostat, regulates body temperature through a thermoregulatory setpoint. It receives signals from cold and warm thermal receptors throughout the body and adjusts the body's temperature accordingly. Fever occurs when this hypothalamic setpoint is altered, usually in response to an infection or illness.
Factors Affecting Body Temperature01:28

Factors Affecting Body Temperature

As a nurse, it is vital to understand the factors affecting body temperature to monitor variations and effectively evaluate deviations from regular.
Factors may  include:
Masonry in Cold and Hot Weather Conditions01:21

Masonry in Cold and Hot Weather Conditions

In cold weather, masonry construction requires specific precautions to ensure mortar does not freeze before curing, as this can significantly weaken its strength and watertightness. Mortar temperature should be maintained between 60°F and 80°F to support proper hydration and curing. Below 40°F, mortar water must be heated, but should not exceed 120°F as high temperatures can reduce mortar's compressive and bond strength.
Other key practices include keeping masonry units and sand dry and...
PPE Use in Healthcare Settings II: Doffing01:10

PPE Use in Healthcare Settings II: Doffing

The sequence of removing or doffing PPE starts with the gloves, as they are the most contaminated. Next is removal of the face shield or goggles, as they would interfere with removing other PPE. Then remove the gown, followed by the mask or respirator. Perform hand hygiene between steps if hands become contaminated and immediately after removing all PPE. Generally, the outside front and sleeves of the isolation gown, the goggles or the mask, the respirator, and the face shield are contaminated.
Burn Injuries01:22

Burn Injuries

Burn injuries occur when the skin and underlying tissues are damaged due to exposure to heat, electricity, chemicals, radiation, or friction. They can vary in severity, from minor superficial burns to severe deep burns that can be life-threatening.
The damage results in the death of skin cells, which can lead to a massive loss of fluid. Dehydration, electrolyte imbalance, and renal and circulatory failure follow, which can be fatal. Burn patients are treated with intravenous fluids to offset...