Related Experiment Video
Updated: May 28, 2026

Reactive Vapor Deposition of Conjugated Polymer Films on Arbitrary Substrates
Published on: January 17, 2018
3,4-Disubstituted polyalkylthiophenes for high-performance thin-film transistors and photovoltaics
Sangwon Ko1, Eric Verploegen, Sanghyun Hong
1Department of Chemistry, Stanford University, Stanford, California 94305, USA.
Abstract:
We demonstrate that poly(3,4-dialkylterthiophenes) (P34ATs) have comparable transistor mobilities (0.17 cm(2) V(-1) s(-1)) and greater environmental stability (less degradation of on/off ratio) than regioregular poly(3-alkylthiophenes) (P3ATs). Unlike poly(3-hexylthiophene) (P3HT), P34ATs do not show a strong and distinct π-π stacking in X-ray diffraction. This suggests that a strong π-π stacking is not always necessary for high charge-carrier mobility and that other potential polymer packing motifs in addition to the edge-on structure (π-π stacking direction parallel to the substrate) can lead to a high carrier mobility. The high charge-carrier mobilities of the hexyl and octyl-substituted P34AT produce power conversion efficiencies of 4.2% in polymer:fullerene bulk heterojunction photovoltaic devices. An enhanced open-circuit voltage (0.716-0.771 eV) in P34AT solar cells relative to P3HT due to increased ionization potentials was observed.
More Related Videos
08:29Morphology Control for Fully Printable Organic–Inorganic Bulk-heterojunction Solar Cells Based on a Ti-alkoxide and Semiconducting Polymer
Published on: January 10, 2017
08:59Concurrent Quantitative Conductivity and Mechanical Properties Measurements of Organic Photovoltaic Materials using AFM
Published on: January 23, 2013